
Chimney waterproofing in Switzerland by local experts
Brick, stone or stucco chimneys in Switzerland treated with a product whose sheet lists that surface. Local pros inspect for free.
- Family owned and operated
- Free inspection and estimate
- Same-day service available
- Upfront pricing, no hidden fees
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
or call (904) 920-5495
Why Choose Us
Waterproofing specialists who test Switzerland brick first
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off when you book today
We use breathable repellents, so moisture already inside the brick can still dry out.
- Free inspection and estimateWe splash test your Switzerland chimney at no charge and tell you if the brick needs treatment at all.
- No hidden feesRepairs and repellent are separate lines, and nothing is added once the spraying starts.
- 100% satisfaction guaranteedIf treated brick still soaks up water where we sprayed, we come back and put it right.
Stucco and stone chimneys
Stucco, stone and concrete block chimneys can be treated too, depending on the product. The sheet for the siloxane repellent we apply lists portland cement stucco, natural stone and concrete masonry units among its surfaces, alongside clay brick. Each takes the product differently, so the trial patch matters more on these.
Stucco with open cracks lets water in behind the finish, and those cracks are repaired first. Stone chimneys with wide or open joints are repointed before any treatment. Where your Switzerland chimney is not bare brick, the surface is named and the product checked against it. Call (904) 920-5495 and our waterproofing pros will test your Switzerland brick for free.
Switzerland sits inland, more than about six miles from the coast. Counted as a direct line, Jacksonville and Switzerland are roughly 14 miles apart.
What's Included
What chimney waterproofing covers in Switzerland
- Brick cleaned so the repellent reaches the pores
- Old film sealer tested and removed where it blocks treatment
- Breathable silane or siloxane repellent, product named
- Flood coat applied from the bottom up
How It Works
From splash test to cured repellent in Switzerland
-
Water test on brick and joints
We wet the faces and watch where the brick drinks, and check the crown, cap and flashing for openings.
-
Openings repaired, then cured
Joints, brick, crown and flashing are fixed first, and the data sheet's cure time runs before any treatment.
-
Test patch, then a flood coat
A patch shows how your brick takes the product. Then it goes on from the bottom up with a low-pressure sprayer, wet on wet.
-
Splash test and paperwork
Treated brick should bead water and stay light. You get the product, the faces treated and the cure time in writing.
Local Conditions
White powder on Switzerland chimneys
White deposits on brick are salts carried out by water as it dries. While they keep coming, water is still moving through the masonry.
We find where the water enters and fix it, and a repellent goes on only after the deposits have stopped.
10% off your first service when you book today
First job with us? A tested, treated chimney is 10% off.
Siloxanes and clay brick
Siloxane molecules are larger than silanes, and they link chemically to the silica and alumina in fired brick and in mortar. In BIA's assessment they give good penetration and repellency and have worked well on certain brick walls, which is why the note suggests a siloxane, or a siloxane and silane blend, for exterior brick. Some siloxanes tolerate a slightly damp surface. The one we apply on chimneys is a modified siloxane, and its maker describes it reacting with the minerals in the masonry, in the presence of ultraviolet light and moisture, to form a water-repellent zone just below the face. Nearby glass needs protecting for the same chemical reason, since glass is mostly silica.
Holding off while salts are still coming out
White efflorescence is a sign that water is still travelling through the masonry and depositing salt where it dries. BIA's position is that brickwork with a history of it should be coated only after the moisture source has been corrected, because salts that cannot reach the surface may crystallize just behind it and break the face. So the steps run in order: the deposit is brushed off dry, the water path is found and repaired, and the wall is watched for fresh deposits before any treatment is booked. If the white returns, the repair is not finished, and treatment waits.
Repellent does not seal the roof joint
The roof joint around a chimney is sealed with metal: step flashing woven into the roof covering and counterflashing let into the masonry above it. When that metal lifts, rusts or loses its seal, water runs down between the chimney and the roof framing, without touching the brick faces a repellent protects. Stains on a ceiling near the chimney, or wet framing in the attic beside it, send us to the flashing before any treatment is priced. Flashing repair is its own job, and damage to the roof covering itself is referred to a roofer.
Free Inspection
Repairs and treatment, priced apart
- Joint, brick, crown and flashing repairs listed before any treatment
- Covering glass, roofing, siding, paint and plants from overspray
- Application method and coverage rate from the maker's sheet
- Clean-up of overspray on nearby surfaces the same day
FAQ
Waterproofing questions from Switzerland
Do you waterproof chimneys in Switzerland?
We do, as part of our chimney work there. A visit starts with a look at how water is getting in, and treatment is only recommended when the brick itself needs it.
Can the treatment be done the same day as repointing?
No. Fresh joints need at least 72 hours to cure first, according to BIA and the product's data sheet, so treatment is a second visit.
Our Services
More services in Switzerland
-
Chimney Liner Installation and Relining A listed stainless liner sized to the appliance and run the full flue height.
-
Chimney Flashing Repair The metal joint between roof and chimney, re-formed so rain runs past it.
-
Chimney Rebuild Loose, cracked or leaning masonry taken down to sound brick and relaid.
-
Gas Fireplace Repair and Service Gas units that will not light, stay lit or burn right, plus service.
-
Chimney Crown Repair The concrete top of the chimney, sealed or recast so it sheds water again.
-
Chimney and Fireplace Inspection The whole system checked against NFPA 211, with findings shown on site.
Learn more about chimney waterproofingAll services in Switzerland
Damp brick, free test
A simple splash test shows whether your brick in Switzerland soaks up rain. Call (904) 920-5495 to have our masonry experts run it.
Free Inspection