Local chimney rebuild in Northside
Rebuilding in Northside means taking down only what has failed, and a free inspection shows where that line falls.
- Family owned and operated
- Free inspection and estimate
- Same-day service available
- Upfront pricing, no hidden fees
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
or call (904) 920-5495
Why Choose Us
Rebuild specialists who test every course in Northside
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off when you book today
Counterflashing goes into the new joints as the stack rises, which is the right time to set it.
- Family owned and operatedOur family business takes your Northside chimney down by hand and lays it back up itself.
- Upfront pricing, no hidden feesThe take-down line, flue plan and crown are priced before the first brick comes off.
- Workmanship warrantyFrom the new courses to the counterflashing, the rebuilt stack carries our workmanship warranty.
Permits for a chimney rebuild
Whether a rebuild needs a permit, and what inspections come with it, is for the local building department to decide, since the work is structural masonry. We do not guess on your behalf: the estimate states our expectation on the permit and who applies.
Where inspections apply, they fall at set points, such as before the crown pour or at the end, and the schedule allows for them. If no permit is needed, the estimate says that too. Keep the permit record with the Northside house papers, since a future buyer may ask for it. Tell us what you see from the ground; (904) 920-5495 reaches our rebuild team in Northside.
Northside lies inland, over six miles from the coast. Measured in a straight line, Northside is about 13 miles from Jacksonville.
What's Included
Rebuild work around Northside
- Each course tested by hand to set the take-down line
- Brick lowered by bucket or chute, never thrown
- Finished height checked against the code's height rule
- Cap anchored once the crown has cured
How It Works
How our rebuild specialists work in Northside
-
Take-down line marked
We test each row of brick from the top down and mark where sound brick starts.
-
Old brick taken down by hand
The flue is covered and the roof protected, then brick comes off a row at a time, with sound brick saved to relay.
-
Relaid plumb around the flue
Brick goes back in matched mortar with tooled joints, around new clay tile or ready for a listed liner, and is flashed into the roof.
-
Crown cast, cap on last
A new crown with an overhang and a drip edge cures before the cap goes on and the first fire is lit.
Local Conditions
Two flues in one rebuilt stack in Northside
Where two flues run in one chimney, the code wants a masonry divider at least 4 inches thick between them, so smoke and heat stay in their own flue.
A rebuild in Northside that opens both flues puts that divider back in full.
10% off your first service when you book today
A first rebuild with us is 10% off.
Where new flue tile starts and how far it may lean
The code sets where clay tile begins. For a flue serving an appliance, it starts no less than 8 inches under the lowest inlet; for a fireplace, it starts at the top of the smoke chamber, and it runs to a point above the enclosing walls (FBC R1003.12).
The tile runs vertically where it can, and where it must offset, the slope stays within 30 degrees of vertical. A rebuild that goes low enough to reach the smoke chamber rebuilds that starting point too, and you know in advance how far down the new tile begins. The first tile sits on a solid base, clear of loose rubble.
Keeping the rebuilt masonry off the framing
A rebuild that reaches into the attic has to keep its distance from wood. The code wants a 2-inch airspace between combustibles and any part of a masonry chimney that runs through the interior or is built into an outside wall, and 1 inch for a chimney standing wholly outside, including where it passes a soffit or cornice (FBC R1003.18).
Framing that was built tight to the old stack is noted, and the rebuilt masonry is laid to hold that gap. Where a roof deck edge touches the brick, it is trimmed back as part of the tie-in.
Fireblocking where the rebuilt stack passes a floor
Noncombustible fireblocking, securely fixed, has to fill the space between masonry and framing at each floor or ceiling the stack passes (FBC R1003.19). Against wood joists, beams or headers, that fireblocking has to be self-supporting or be laid on metal strips or lath.
Below the roofline, a rebuild passes those points and puts the fireblocking back as it goes. Any combustible fill found stuffed around the old stack, such as paper-faced insulation or scrap wood, is removed and replaced. The gaps are measured so the new fireblocking fits snugly. Access panels are left where the work can be inspected.
Free Inspection
Tested before a rebuild is priced in Northside
- Roof around the stack protected where debris lands during the work
- Joint profile tooled concave or V once the mortar firms
- Height checked against the roof and anything within 10 feet
- Permit expectation, who files, and where inspections fall in the schedule
FAQ
Before the first brick comes off
Can the chimney be made taller during the rebuild?
Yes, when the code's height rule calls for it. The added courses are laid before the crown, and the flue tile or liner is lengthened to match.
Does a rebuild qualify for the first-service offer?
Yes. It applies if the rebuild is your first job with us; just ask for 10% off your first service on the call.
Our Services
More services in Northside
-
-
-
-
-
-
Sound brick up to a new crown in Northside
Family-owned masonry professionals mark the take-down line on your Northside chimney at no charge.
Free Inspection