Chimney mortar repair for homes in Brooklyn

Mortar matched to your brick in type and color, packed into your Brooklyn chimney joints under our satisfaction guarantee.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Local repointing pros for Brooklyn chimneys

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Deep joints are filled in layers and tooled, not skimmed over.

Free inspection and estimateEvery face of your Brooklyn chimney is scratch-tested and sketched at no charge.
100% satisfaction guaranteedIf the new joints are not sound, full and matched as agreed, we come back and fix them.
Family owned and operatedA family masonry crew does the survey and the work, so the person who priced a face is the one who repoints it.

Call (904) 920-5495 Free Inspection

Crumbling mortar in the attic

The part of a chimney that passes through the attic is easy to forget. Its joints can wear too, and there they matter for more than looks, because gaps in an interior chimney's mortar can let heat and flue gas out beside the framing.

If you can reach the attic, a look with a flashlight at the chimney's sides tells a lot. Sandy or open joints there go on the estimate as interior repointing. Mortar crumbling on the chimney in your Brooklyn attic? Phone (904) 920-5495; our masonry team inspects for free.

Brooklyn is one of the named neighborhoods of Jacksonville. Brooklyn falls within Duval County.

Raked, filled, tooled and cured

Every face scratch-tested and sketched
Color matched from a cured sample
Fresh work shaded, misted and covered from rain
A repointing sketch of your Brooklyn chimney, free

Call (904) 920-5495 Free Inspection

How chimney tuckpointing runs

Every face surveyed
Joints are scratch-tested at several heights and the failed courses marked on a sketch.
Joints raked and cleaned
Old mortar comes out to sound depth, head joints by hand, then joints are cleaned and dampened.
Filled in layers and tooled
Matched mortar goes in stage by stage, then is tooled to the original profile.
Cured and cleaned up
Fresh joints are protected while they cure, the faces brushed and the roof cleared.

The top courses on chimneys in Brooklyn

The courses above the roof take weather from every side, inland or not, and their joints usually wear before the rest.

On Brooklyn chimneys we check the top first and price it separately from the lower stack.

10% off any service booked within 72 hours of inspection

Sandy joints? Book the repointing within 72 hours of the survey and 10% comes off.

Call (904) 920-5495 Free Inspection

Getting the mortar color right

Mortar color comes mostly from the sand, with the binder shifting the shade. Fresh mortar also looks darker wet than it will dry, so judging a match from the bucket goes wrong.

We make a small test batch, let it cure against the brick and compare it with the old joints in daylight. The mix is adjusted until it reads as part of the same wall. Where the old joints have weathered unevenly, we match the tone that covers the greater part of that face and show you the sample before the work begins. The approved sample stays on site as the reference for every batch mixed after it.

Mortar inside the house and attic

The exterior of a chimney gets the attention, but the section inside the house and attic has mortar joints too. There, a failed joint is not only a cosmetic issue, since the chimney wall sits close to the framing.

Where the chimney is visible in the attic or a closet, we check those joints with a light. Sandy or open joints on the interior are repointed with the same care as outside, with the space protected from dust. They are listed separately on the estimate because the access and cleanup are different. Any joint there that looks scorched or blackened is noted for a flue check as well, since it may point to a leak from inside.

Protecting fresh joints from the weather

Fresh mortar is vulnerable for its first days. A heavy rain can wash the surface out of a new joint, and strong sun or wind can dry it too fast.

We watch the forecast when scheduling, cover fresh work when rain is likely and shade sun-facing sides as needed. If the weather turns partway through, work stops at a clean edge rather than leaving half-filled joints. These pauses are part of doing repointing properly, and the estimate allows for them without surprise charges. Covers stay on until the joints have firmed enough to take a shower without losing their surface.

What goes on a repointing sketch in Brooklyn

Raking depth for each face, set by joint width
Spalled or cracked bricks to replace before their joints
Weather protection and curing for the new joints
Days on site and the wait before the next fire

Before the joints are raked

Do you repoint chimneys in Brooklyn?

Yes. Our masons repoint chimneys across Duval County, Brooklyn included. Mention the sandy sides on the phone, and those faces are surveyed first, at no charge.

Which mortar will you use?

A type from ASTM C270 picked for your brick and its exposure, normally weaker than the brick itself, in line with preservation guidance. The type is written on the estimate.