ODS pilot and log service for vent-free fireplaces in Springfield

Logs moved, embers scattered or burner clogged, your Springfield vent-free set is serviced to the maker's photos.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Vent-free experts who never bypass a safety shutoff

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Every gas joint we open is leak checked before we leave.

Free inspection and estimateThe rating plate, the room and the flame of your unit in Springfield are checked on a free visit.
Upfront pricing, no hidden feesCleaning, listed parts and labor are priced in writing before anything is ordered or fitted.
100% satisfaction guaranteedIf the unit does not run the way we said after our service, we come back and put it right.

Call (904) 920-5495 Free Inspection

Running the set with the damper closed

Running a vent-free set with the fireplace damper closed is allowed only where its manual says so, for example when the surroundings are noncombustible and the mantel clearances are met. Otherwise the manual has the damper open, and the set runs vented. The manual's conditions depend on the fireplace around the set, not only on the set itself.

We check your fireplace in Springfield against the manual's conditions and explain which way the set may be run. The damper position is written on the ticket along with the reason.

The coastline lies beyond Springfield. Hogan's Creek park system lies within Springfield.

Vent-free fireplace service we handle in Springfield

Listed ODS pilot assemblies replaced
Burner ports and air inlets cleared
Soot problems traced to their cause
Mantel clearances measured against the manual

Call (904) 920-5495 Free Inspection

How our crew services a vent-free unit in Springfield

Rating plate and gas confirmed
The model, gas, listing and input are read and the gas confirmed at the valve before parts are ordered.
Room measured against the code
The room volume and every unvented input in it are compared with the code and the manual.
Pilot, burner and logs serviced
The sensor pilot and burner are cleaned, the logs set to the diagram and worn parts replaced.
Leak checked and run through a cycle
Opened joints are leak checked, the flame is watched through a full cycle and findings are written down.

Candles and residue indoors in Springfield

Soot on the walls near a vent-free unit in Springfield can come partly from candles or other products used in the room, which makers warn about. The coast has no part in that.

When soot appears, the room is checked as well as the flame.

10% off any service booked within 72 hours of inspection

Cleaning, log placement or a new sensor, each is discounted.

Call (904) 920-5495 Free Inspection

Ember material and where it goes

Vent-free sets may use rock wool, glowing embers or vermiculite to finish the look. Manuals say where it goes and how much, and one places rock wool at the front of the burner only. Too much, or ember material over the ports, disturbs the flame.

We remove old ember material that has spread onto the ports and replace it in the amount and position the manual shows. The ticket notes what was used, so it can be matched next time. Old ember material that has been sitting in soot is replaced rather than reused.

The water a vent-free unit makes

Burning gas makes water vapor, and a vent-free unit leaves it in the room. One manual figures roughly an ounce of it per hour for every thousand Btu of input, and warns that a room without enough ventilation air can grow mildew.

Fogged windows, damp corners or a musty smell near a unit point to a room that is too closed or too small for its input. We measure the room, and the estimate explains whether the unit suits it. Condensation on cold windows or walls near the unit is the first visible sign of it.

Leak checks after every repair

Any gas connection opened during service is tested before the unit is returned to use. The National Fuel Gas Code calls for leak checks with a leak-detection solution or an instrument, and rules out matches, candles or any open flame for the purpose.

We test each fitting we touched at operating pressure and write down that it was checked. A leak found upstream of the appliance's shutoff is named for the gas utility or a gas contractor. A leak found is fixed and rechecked before the unit is lit.

What we check on a vent-free unit in Springfield

Ember material replaced in the amount and place the manual shows
Inlet and manifold pressure measured against the rating plate
Every opened gas joint leak checked with solution or instrument
Bedroom, bathroom and sole-heat rules checked for the unit

Before the unit is lit again

Why is there soot on my wall?

Logs out of place, flame touching the logs, a dirty burner, drafts or candles in the room are the usual sources. We check each one and fix the cause before the wall is cleaned.

Do you work on the gas line to the unit?

No. We service the appliance from its shutoff valve in. Supply piping and new gas lines belong to a gas contractor or the gas utility, and we name them when they are needed.