Local gas insert installation for San Jose homes
Your San Jose gas insert priced part by part in writing, from liners to surround, with the gas and power trades named. No hidden fees.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Local gas insert specialists who install to the listing
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
We light the insert with you and walk through the controls before leaving.
- Free inspection and estimateThe opening, flue and mantel of your San Jose fireplace are measured against the insert's plate at no charge.
- Upfront pricing, no hidden feesInsert, vent kit, surround, cleaning and repairs are priced line by line, and the gas and power trades are named.
- 100% satisfaction guaranteedIf the insert does not light, burn or seal the way its manual describes after our installation, we come back.
Done with hauling wood
Plenty of people with a masonry fireplace reach a point where lighting a wood fire is more work than they want. A sealed gas insert fits into the existing opening, lights at a switch or remote, and sends its exhaust up the old chimney through its own pipes, with the glass front keeping room air out of the flame. Nothing about the fireplace's look has to change beyond the new front.
Size, flue and the mantel overhead settle whether your fireplace can take one, and all three get checked before you pick a model. Ready to switch to gas in San Jose? Book the free inspection at (904) 920-5495.
The county for San Jose is Duval County. San Jose does not reach the coast.
Gas insert work for San Jose fireplaces
- Sealed direct-vent gas inserts installed to their manuals
- Co-linear liners run to a listed termination
- Pressure readings taken at the valve
- Barrier screens and relief doors checked
From wood fireplace to gas insert in San Jose
-
Measure against the plate
Opening, flue and mantel are checked against the insert's rating plate and manual.
-
Clean and check the chimney
The old flue is cleaned, examined and repaired if needed before the liners go up.
-
Liners, insert, surround
The vent kit runs to its termination, the insert is set and the surround fitted.
-
Hookups and first light
The gas and electrical hookups are made, then we light and test the insert with you.
A chimney with two flues in San Jose
A chimney in San Jose with two flues needs sorting out first, since the gas insert gets a flue to itself.
We trace each flue first.
10% off any service booked within 72 hours of inspection
Liner, insert and the light-up checks at your San Jose home are all discounted.
Co-linear venting, two liners side by side
A co-linear system uses two separate flexible liners inside the old flue: one brings outdoor air to the insert, the other carries exhaust away. One maker's kit uses a 3-inch liner for intake and a 4-inch liner for exhaust, both two-ply flexible liner approved for venting gas appliances.
At the bottom, an adapter joins them to the insert's collar; at the top, a co-linear termination kit and its flashing close the chimney. Co-linear kits are common in fireplace conversions because two small flexible liners get past a narrow throat more easily than one large rigid pipe.
Aluminum or stainless liners
Aluminum and stainless are the two flexible liner choices in co-linear kits. One maker wants aluminum liners looked at by a professional from time to time for corrosion and damage, and calls for stainless wherever the liners could not be reached again later.
A liner hidden behind a finished chimney or a sealed top is one that cannot easily be reached later, and that pushes the choice toward stainless. We decide with you on the visit, and the estimate names the material and why it was chosen. Where the top of the chimney stays open to inspection, aluminum can be a reasonable choice.
The old damper and the liner route
The fireplace throat, where the damper plate sits, is the gateway for the liners. The plate is taken out or pinned wide open so the liners pass freely, and on some fireplaces part of the damper frame has to be trimmed to give them room.
Removing or fixing the damper is part of the install, done after the chimney is cleaned and before the liners go up. We write down what was done to the damper on the ticket, since anyone who later pulls the insert out needs to know the fireplace was altered before lighting a wood fire in it.
Opening, flue and mantel on paper
- Vertical height and offsets measured against the vent limits
- Liner bend radius kept through the throat and smoke shelf
- Termination and flashing at the chimney top, with the top checked first
- Gas supply by the gas trade, with pressures read at the valve
Gas insert questions from San Jose
Who runs the gas line?
The gas trade does: a gas contractor, the gas company or your propane supplier. Their part is on the estimate with a date, and our hookup follows once gas reaches the valve.
What is co-linear venting?
Two flexible liners run up the old flue, one bringing outdoor air in and one taking exhaust out. They join the insert at the bottom and a termination at the top.
More services in San Jose
-
-
-
-
-
-
Learn more about gas fireplace insert installationAll services in San Jose
Book a gas insert check in San Jose
Gas inserts we fit in San Jose follow their manuals line by line, and our satisfaction guarantee covers the result.
Free Inspection