
Chimney and fireplace service for Orange Park homes from local experts
Chimney work in Orange Park starts with a free inspection and goes one job at a time.
- Family owned and operated
- Free inspection and estimate
- Same-day service available
- Upfront pricing, no hidden fees
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
or call (904) 920-5495
Our Services
Chimney and fireplace services in Orange Park
-
Chimney Sweep in Orange Park Soot and early creosote brushed out of the flue, smoke chamber and firebox.
-
Gas Fireplace Repair in Orange Park Gas units that will not light, stay lit or burn right, plus service.
-
Fireplace Repair in Orange Park Firebox, damper, hearth, surround and smoke problems on any fireplace.
-
Chimney Inspection in Orange Park The whole system checked against NFPA 211, with findings shown on site.
-
Chimney Cap in Orange Park Rain, animals and embers kept out of the flue by a fitted cap.
-
Chimney Liner in Orange Park A listed stainless liner sized to the appliance and run the full flue height.
- Chimney Repair in Orange ParkAny failed part of the stack, found, named and fixed in a sensible order.
- Flashing Repair in Orange ParkThe metal joint between roof and chimney, re-formed so rain runs past it.
- Chimney Leak Repair in Orange ParkWater coming in at the chimney, traced by testing and stopped where it enters.
- Crown Repair in Orange ParkThe concrete top of the chimney, sealed or recast so it sheds water again.
- Chimney Masonry in Orange ParkCracks, open joints and damaged brick repaired with matched mortar.
- Waterproofing in Orange ParkBrick that soaks up rain treated with a breathable repellent.
- Chimney Rebuild in Orange ParkLoose, cracked or leaning masonry taken down to sound brick and relaid.
- Chase Cover in Orange ParkA rusted or ponding chase top replaced with one that drains.
- Fireplace Installation in Orange ParkNew and replacement fireplaces, factory-built or masonry, with their chimneys.
- Gas Fireplace Install in Orange ParkDirect-vent and B-vent gas fireplaces, framed and vented to the manual.
- Animal Removal in Orange ParkAnimals and nests cleared from the flue, debris cleaned out, entry closed off.
Working with us in Orange Park
Clearance to combustibles is the gap between hot parts of a fireplace or chimney and anything that can burn, and it is checked on every fireplace we look at, whatever its age. For a masonry fireplace, the Florida Building Code asks for at least 2 inches between wood framing and the front faces and sides, and 4 inches at the back.
Combustible trim and mantels may sit on the masonry face but not within 6 inches of the opening, and within 12 inches of the opening they may project no more than one-eighth inch for each inch of distance. A masonry chimney inside the house needs 2 inches of airspace to combustibles, and one entirely outside the exterior walls needs 1 inch.
Factory-built fireplaces and chimneys have their clearances set by their listing, and the numbers are printed in the manual and sometimes on the rating plate. The hearth extension in front of the opening also has minimum sizes in the code. Clearances get lost over time, when a mantel is added, a wall is paneled, or trim is run up to the opening during a remodel.
We measure what can be reached from the room, the attic and the chase, and where a clearance falls short, the estimate marks the spot and what it would take to correct it. Some fixes are simple, such as trimming back a wood edge, while others mean rebuilding a surround. The estimate says who does any mantel or trim carpentry that a correction to the clearances needs.
Heat damage shows up as darkened or charred wood near the opening or in the attic beside the chimney, and either one means the fireplace stays cold until someone qualified has looked at it. Factory-built units also need their clearances checked at the chase, where framing, insulation and firestops sit close to the listed chimney sections.
The clearance check is part of every visit we make in Orange Park, and anything too close is written up. Orange Park homeowners can call (904) 920-5495 for a same-day visit when the schedule allows.
About Orange Park
- Orange Park sits in Clay County.
- At the 2020 Census, Orange Park was home to 9,089 people.
- Orange Park sits inland, more than about six miles from the coast.
- Orange Park is on the St. Johns River.
- Orange Park sits about 10 miles from Jacksonville, measured directly.
Sources: 2020 Census; Census TIGER/Line 2020; Wikipedia; computed from coordinates

How It Works
Four simple steps
-
You call or send the form
A person answers, asks what you are seeing and sets a time that works for you.
-
We look before we price
We inspect the parts involved, from the firebox up to the top of the flue, and show you what we find.
-
Written estimate
You get the scope and the price in writing before any work starts. No charge for the estimate.
-
The work, then a walk-through
We do the job we wrote down, clean up, and walk you through what changed.
Service Areas
Areas near Orange Park
- Bellair-Meadowbrook Terrace3 mi
- Fleming Island4 mi
- Lakeside4 mi
- Fruit Cove6 mi
- Oakleaf Plantation8 mi
- Jacksonville10 mi
FAQ
Questions from Orange Park
How does the 10% off first service work?
New customers in Orange Park get 10% off their first service with us. It is printed as a separate line on the estimate, so the reduction is plain to see. It applies to the first job you book, whether that is a sweep, a repair or gas fireplace service.
Do chimney repairs need a permit?
Some do and some do not, and the local building department makes that call. Rebuilding a chimney, adding a fireplace or installing a new gas appliance is the kind of work that goes through a permit and a final inspection by the building department. Like-for-like repairs such as a new cap or repointing may not. When a permit applies, the estimate says so and names who applies for it.
Can you work alongside my roofer?
Yes, and it can save a second trip up the roof. When a roof is being replaced, the chimney flashing is the joint where our work and the roofer's meet, so we agree beforehand who installs the step flashing and who cuts in the counter flashing. We do not replace roof coverings. If the roof itself has failed around the chimney, we say so and leave that part to the roofer.
Get a free chimney inspection
Call or send the form. The inspection is free and the price is written down before any work.
Free Inspection