Local hearth repair in O'Neil

Loose tile on a hearth in O'Neil gets a free visit from local specialists who check the slab underneath.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Hearth experts who measure before they tile

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Heights at the firebox, the doors and the floor are checked before the slab is set.

Free inspection and estimateYour hearth in O'Neil is sounded, leveled and measured on a free visit before any price is written.
100% satisfaction guaranteedA tile or stone we set that comes loose is ours to fix, and we return to reset it.
Family owned and operatedA family-owned local crew explains each layer of the repair, from the support to the grout line.

Call (904) 920-5495 Free Inspection

Tile loosened by water from above

Rain that gets past an open flue top ends up on the inner hearth and runs forward. Over time it softens setting beds, stains grout and lifts tile near the opening. Resetting that tile before the water is stopped puts the same tile back in the path of the next rain.

At a hearth in O'Neil with water marks, we trace the water upward, to the cap or the flue top, and write that repair beside the hearth work. Then the tile goes back on a dry, sound bed. The inspection is free, so call (904) 920-5495.

O'Neil is part of Nassau County. O'Neil lies near the coast.

What our hearth crew fixes in O'Neil

Cracked hearth tile cut out and replaced
Crumbling grout raked out and renewed
Ash dump frames and lids reset or replaced
Your hearth in O'Neil measured and sketched before work

Call (904) 920-5495 Free Inspection

The order of a hearth repair

Describe the hearth on the call
Cracked, hollow, sunken or too small, a short description sets up the free visit and what we bring.
Sounding and measuring
Each tile is tapped, the slab's level is read and the extension is measured against the opening.
Support first, surface second
A moving slab or missing support is fixed before tile or stone goes back on a full bed of the named mortar.
Cured before heat, then handed back
The bed cures before grout and fire, and we show you the finished edge and where the clear zone ends.

Rain at the top, stains at the bottom in O'Neil

A chimney near the coast takes wind-driven rain at its top, and an open or damaged cap lets some of it down the flue. The inner hearth is where it lands.

Before we reset hearth tile in O'Neil, we check that the top of the chimney is closed to the weather, and any cap or top repair is listed separately.

10% off any service booked within 72 hours of inspection

A hearth repair booked the same day as the inspection comes 10% off too.

Call (904) 920-5495 Free Inspection

When the firebox floor sits well above the room

A firebox whose floor stands 8 inches or more over the extension changes the thickness rule. At that height the code lets the extension shrink to a thin layer, no less than 3/8 inch, of an approved noncombustible surface such as tile or stone. The exception covers the thickness only.

It does not shrink the size. The extension still runs the distances R1001.10 sets in front and to the sides, measured from the opening. A raised hearth rebuilt with a thin tile surface is fine under the exception, as long as the 8 inches are really there and the tile rests on noncombustible support. We measure that height before choosing the build-up.

Steel in the slab and the concrete over it

Hearths and extensions are built reinforced. Reinforcement helps only while it stays sound, and it stays sound while enough concrete covers it and water stays out. Thin cover near the top surface lets moisture reach the steel, and the rust that forms pushes the concrete off in flakes and pieces.

A patch over rusted steel fails from underneath, so the steel is exposed and cleaned or the slab is recast. We check cover depth where a crack lets us see it and write the finding down. A slab we pour gets its reinforcement placed with concrete cover on every side.

Resetting an ash dump frame

An ash dump is a cast-iron frame and lid set in the inner hearth, with a pit or chute below. The frame is held by mortar, and heat and ash loosen it over time. A loose frame rocks, lets the lid sit crooked and leaves an open seam at its edge.

We chip the frame loose, clean the seat and reset it in refractory mortar, or fit a new frame and lid if the old ones are cracked. The cleanout door at the base of the pit gets checked too, since a door that will not close lets air and pests in. Both parts are priced separately.

What we check on a hearth in O'Neil before pricing

Support under the extension identified, from below where access allows
Flooring or trim inside the clear zone cut back, installer named
Water source above the hearth named and priced as its own line
Room and floors covered, with dust kept to the work area

Before your hearth is lifted

Is a same-day hearth visit possible in O'Neil?

Same-day visits happen when a slot is open that day. Describe the hearth on the call and we give you the earliest time we have.

When can I light a fire on the repaired hearth?

That depends on the setting materials, and each product's data sheet gives a cure time before heat. We write that time on your ticket along with the date the work was finished.