Chimney flue resurfacing and repair in O'Neil
Tile shards in the firebox or a sweep's warning in O'Neil? A free inspection finds the damage, and our crew fixes it.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Family-owned flue experts serving O'Neil
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Resurfacing systems are named with their listing, and installed by their instructions.
- Free inspection and estimateThe flue at your O'Neil home is swept, examined from both ends and mapped at no charge.
- 100% satisfaction guaranteedIf the repaired flue is not sound and correctly sized when we finish, we make it right.
- Family owned and operatedA family business maps the flue and does the repair, so the plan and the work stay in one set of hands.
Rust streaks and a damp flue
Brown streaks on the firebox wall, a damp smell or water on the smoke shelf after rain all point to water getting into the flue. Water soaks mortar joints, and soaked joints crack and wash out faster.
Flue repairs last longer when the water is stopped first. We check the cap, the seal where the tile passes through the top of the chimney and the tile itself, and price the water fix alongside the flue repair. Water showing up in your O'Neil fireplace? Call (904) 920-5495 and book a free flue inspection with our family crew.
O'Neil falls within Nassau County. O'Neil sits a short way inland.
Tile, joint, seal and size
- Seal around the top tile remade
- Gaps at the smoke chamber closed
- Inlet thimbles and cleanout doors checked on appliance flues
- Relining quoted plainly when repair will not hold
How our flue pros repair a flue in O'Neil
-
Swept and examined
The flue is cleaned, then looked over from the roof and the firebox with a light and mirrors.
-
Mapped and measured
Each defect is placed by height and wall, and the flue size is checked against what it serves.
-
Repaired by the chosen method
Top tiles swapped from the roof, damaged sections coated with a listed system, or a relining price when repair will not hold.
-
Checked and cured
The finished flue is examined from both ends and left to cure before the first fire.
Top tiles after storms in O'Neil
Hurricane-season storms can loosen caps and chip top tiles on chimneys near the coast.
A cracked top tile in O'Neil is one of the smaller flue repairs, done from the roof once the weather has cleared.
10% off any service booked within 72 hours of inspection
From one cracked tile to a full relining, flue work in O'Neil is discounted.
How far a flue lining has to run
The lining is meant to run the full height it serves. An appliance flue's lining begins 8 inches or more under its lowest inlet. A fireplace flue's lining begins where the smoke chamber ends. Either way, it finishes above the surrounding chimney walls (R1003.12).
Gaps at either end are common repair points. At the bottom, the first tile may not meet the smoke chamber cleanly. At the top, the last tile may have been cut short or broken back to the crown. We check both ends on every flue, since a sound middle with open ends still lets heat and gas into the masonry.
Heat cracks in clay tile
Clay tile tolerates steady heat better than sudden heat. When a very hot fire meets a cold flue, the inner face of the tile grows faster than the outer face, and the tile can split along its length.
These cracks tend to run vertically and can repeat in tile after tile along the hottest stretch of the flue. A single hairline split in an otherwise sound flue can be resurfaced. Several split tiles, or splits that have opened wide enough to move, point to relining. The flue map shows how many tiles are affected and how far up the damage runs.
How we examine a flue without opening it
Nearly all of a flue is out of reach, so it is examined from its ends. From the roof, we look down with a strong light. From the firebox or cleanout, we look up with a light and mirrors. The tiles are counted from the top, so every defect can be placed by height.
Where a stretch of flue cannot be seen from either end, we say so in writing. We do not guess at a section we could not see, and the estimate notes whether more access is needed before that part can be judged. Knowing what was and was not seen is part of an honest flue report.
What goes on the flue map in O'Neil
- Top tiles to replace from the roof, with the seal around them remade
- Resurfacing system named with its UL 1777 listing, where one is used
- Refractory mortar to ASTM C199 named for any tile reset
- Gaps at the smoke chamber and at the top end of the lining
Before a flue repair is chosen
Does resurfacing make the flue smaller?
A little, because the coat adds thickness to every wall. We measure the flue and the fireplace opening first, and resurfacing is only offered when the flue will still meet the size the code asks for.
What does a flue inspection in O'Neil cost?
The inspection is free, and the flue map with every defect and its price comes with it. Book the repair within 72 hours and you save 10% on it.
More services in O'Neil
-
-
-
-
-
-
A flue that carries the smoke out of your O'Neil home
Our satisfaction guarantee covers the flue work we do in O'Neil, tile by tile and joint by joint.
Free Inspection