Call(904) 920-5495

Throat damper replacement in Mayport

A seized or warped damper in Mayport freed, rehung or replaced by local family damper pros, after a free inspection.

  • Fully licensed and insured
  • Locally owned
  • Family owned and operated
  • Same-day service

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Damper specialists who find the failed part first

  • Locally owned in Jacksonville
  • Family owned and operated
  • 100% satisfaction guaranteed
  • Free inspection and estimate
  • Same-day service available
  • 10% off any service

A cap goes on the estimate when rain is what rusted the damper in the first place.

  • Free inspection and estimateYour Mayport damper is run through its full travel and checked with a light at no charge.
  • 100% satisfaction guaranteedIf the repaired damper does not open fully and close flat, we come back and make it right.
  • Family owned and operatedA family business does the diagnosis and the repair, so the person who quoted it answers for it.

A sooty smell between fires

A stale, smoky smell from a cold fireplace often means air is coming down the flue into the room. Kitchen and bath fans, a clothes dryer and tight construction can pull outside air in through the easiest opening, and a leaky damper is often that opening.

A plate that seals better cuts the airflow, and the smell with it. We check the damper seal, then look at what might be pulling air in, so you know whether the damper is the whole answer. Fireplace smell drifting into the room in Mayport? Call (904) 920-5495 and book a free damper inspection with our family team.

Mayport falls within Duval County. Kathryn Abbey Hanna Park lies within Mayport.

Damper repairs we handle in Mayport

  • Seized plates freed and pivots worked loose
  • Warped or holed plates replaced to fit the frame
  • Poker rods and notch brackets renewed
  • Rust scale cleared from the seat the plate closes on

How our damper pros fix a damper in Mayport

  1. Handle and plate tested

    With the fireplace cold, the control is worked through its travel and the plate checked from below with a light.

  2. Failed part named

    Pivots, plate, frame or control, the part that failed is written down with the repair options and prices.

  3. Freed, rehung or replaced

    Sound parts are cleaned and freed, a plate is matched to its frame, or a new damper is set at code height.

  4. Travel and seal confirmed

    The plate must open fully and close flat under the light before the job is done.

10% off any service booked within 72 hours of inspection

Damper stuck or leaking air? Book the fix up to 72 hours after the inspection and save 10%.

The light test for a damper seal

The simplest damper test needs a dark room and a good flashlight. With the damper closed, the light is held in the firebox pointing up at the plate, and someone in the room looks for light spilling past the edges. On a bright day the test can run the other way, with daylight from the top showing through the gaps.

We use both, depending on the time of day, and we mark where the gaps are. A gap along one edge points to warp or a bent lip. Gaps all round point to scale on the seat or a plate that has dropped on worn pivots. Each has a different fix.

When to close a damper after a fire

Keep the plate wide open until the last ember is dead and the ash is cold to the touch. Closing it over glowing embers sends smoke and combustion gases back into the room, because the flue can no longer carry them away.

That is also why a damper that sticks closed is treated as urgent. If yours cannot be opened, the fireplace should not be lit, however small the fire. We check the handle and plate with that in mind and label the handle positions when they are hard to read, so open and closed are never a guess at the next fire.

What we check before calling the damper done

Four things have to be true before a damper repair counts as finished. The handle or crank moves the plate through its full travel without force. The plate reaches its fully open position and stays there. It closes flat on its seat with no gap visible under a light. And the handle positions are clear to whoever lights the next fire.

We run those checks with you watching, before we pack up. If any one of them fails, the job is not finished, and we say what is still needed. The result is written on the invoice, with the parts used, so the next inspection starts from a known condition.

What we measure on dampers in Mayport

  1. Seat cleaned back to metal and the seal checked under a light
  2. Replacement plate matched by frame size, pivot style and handle lug
  3. Top-sealing damper priced alongside when the throat is hard to reach
  4. Old parts removed and the firebox cleaned before we leave

Before a damper part is ordered

Do you repair fireplace dampers in Mayport?

Yes. Our crew frees, rehangs and replaces throat dampers across Duval County, Mayport included. Describe what the handle does when you call, and the right parts come along to the free inspection.

Why is there a clamp on my damper?

It is probably there for a vented decorative gas appliance, whose instructions require the damper to stay partly open. We leave it while that appliance is installed and remove it only when the fireplace returns to wood.

A damper that seals tight in Mayport

Freeing, rehanging or replacing the damper in your Mayport home is family crew work, and the first look is free.

Free Inspection

Call the chimney and fireplace experts

(904) 920-5495

Free inspection and written estimate

Call (904) 920-5495