Local gas fireplace repair for Fleming Island homes

The failed part, the reading behind it and the part number are named on a free inspection of your Fleming Island gas fireplace.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Gas fireplace specialists who test before replacing

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

A gas fireplace in Fleming Island gets its parts tested with a meter before any of them is replaced.

Same-day serviceWhen the schedule has a gap, a gas fireplace in Fleming Island that will not light can be looked at the same day.
Upfront pricing, no hidden feesYou see the reading that proved the fault, the part and its price in writing, and then you decide.
100% satisfaction guaranteedIf the fireplace still will not light or stay lit after our repair, we come back.

Call (904) 920-5495 Free Inspection

Where the appliance ends

Our work on a gas fireplace runs from the appliance shutoff valve through the controls, burner, glass and vent. The gas piping that brings fuel to that valve belongs to a gas contractor, the gas utility or the propane supplier, and a new outlet or circuit for a blower or ignition module belongs to an electrician. When a repair in Fleming Island turns up a problem on their side, such as low supply pressure or a dead outlet, we name it and who to call, and come back to finish once it is fixed. That keeps each fix with the trade that can stand behind it. Call (904) 920-5495 from Fleming Island with the make of the unit, and we will check parts first.

Fleming Island is an inland community. Fleming Island lies on the St. Johns River.

Gas fireplace repairs in Fleming Island homes

Pilot flame checked against the manual's drawing
Gas pressures read at the valve test ports
Burner ports cleaned and ember material reset
Logs placed back on the manual's diagram

Call (904) 920-5495 Free Inspection

How our gas fireplace pros find the fault in Fleming Island

Rating plate and symptom
We read the maker, model and gas type, then watch the unit try to do what you called about.
Readings against the chart
Thermocouple, thermopile or flame rod output and the gas pressures are measured and compared with the manual.
Failed part replaced
The part that tested bad is replaced with the maker's listed part, and the burner and logs are set right.
Test burn and vent check
The unit runs through a full cycle, and the vent termination outside is checked before we go.

Glass gaskets on sealed units in Fleming Island

A direct-vent fireplace is sealed from the room, and the glass front is part of that seal. A flattened or torn gasket lets the seal leak.

We check the gasket on sealed units in Fleming Island and fit the maker's glass assembly when it is worn.

10% off any service booked within 72 hours of inspection

Gas fireplace will not light? Book the repair within 72 hours of the inspection and 10% comes off.

Call (904) 920-5495 Free Inspection

A blocked pilot orifice

The pilot orifice is a tiny drilled opening, and a spider web, a speck of dust or a bit of scale is enough to shrink the flame or stop it. A weak pilot then fails to heat the thermocouple or thermopile fully, and the symptoms look like a bad sensor.

Before any sensor is replaced, we check the flame and, where the pilot design allows, clear the orifice and the air opening around it. Where the maker supplies the pilot as a single assembly with its sensors, the whole assembly is replaced as one part rather than rebuilt. The flame is checked again afterward.

The screen in front of hot glass

The glass front of a gas fireplace gets hot enough to burn skin. Under the 2015 revisions of ANSI Z21.88 and Z21.50, units whose glass runs above a set temperature ship with a barrier, such as a mesh screen, in front of the glass. The manuals say the barrier shall be installed.

On older units built before that change, a barrier may be available from the maker as an accessory. We check that the screen is present, fastened as designed and undamaged, and replace a missing or bent one with the maker's part. Burns to children are the reason the rule exists.

Carbon monoxide and a gas fireplace

A vented gas fireplace is built to send its exhaust outside, and carbon monoxide becomes a risk inside when that path fails: a blocked vent, a leaking joint, a gasket that no longer seals or a burner running rich. The manuals list the early signs of exposure as flu-like, headaches, dizziness and nausea, and tell you to get fresh air at once and have the unit inspected.

A carbon monoxide alarm near the sleeping rooms is the backstop, since the gas has no smell. Service checks the vent path and the seal each visit. The alarm does not replace the yearly check of the vent.

Measured in Fleming Island before a part is replaced

Thermocouple or thermopile output read under load and compared with the chart
Leak check with solution on each connection opened or replaced
Blower cleaned, and its thermal switch and speed control tested
Remote receiver and wall switch circuit tested at the valve

Before a part is ordered

Can you fix a gas fireplace in Fleming Island the same day?

Whenever an open slot allows, same-day service is available. A repair can be finished on the first visit when the part is on the truck, and parts that have to be ordered are listed on the estimate with their expected date.

Can my gas fireplace be used with cracked glass?

No. The manuals do not allow a sealed unit to run with cracked, broken or missing glass, because the glass is part of the seal that keeps exhaust out of the room. Leave it off until the maker's glass assembly is fitted.