Gas log installation for Arlington homes
Vented logs with the damper clamped open, or vent-free logs where the room allows, installed in Arlington to the listing.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Gas log pros who measure first in Arlington
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
The first light is done with you, flame compared with the manual.
- Free inspection and estimateYour Arlington firebox, flue, damper and room are measured against the set's manual at no charge before anything is bought.
- Upfront pricing, no hidden feesSet, burner, clamp, cleaning and any repairs are priced in writing, with the gas trade's part named.
- 100% satisfaction guaranteedIf the flame is sooty or the set will not stay lit after our installation to the manual, we come back.
Moisture from vent-free logs
Every vent-free flame puts water into the room along with its heat. In a room that already runs damp, that extra moisture can feed mildew, and vent-free makers describe their sets as supplemental heat rather than the main heat for a house. A room with a dehumidifier running already is a warning sign for vent-free.
How you plan to use the logs matters, so that conversation comes before any recommendation. Thinking about vent-free logs in Arlington? Ask us at (904) 920-5495.
Arlington is one of the named neighborhoods of Jacksonville. Arlington is part of Duval County.
Gas log work for Arlington fireplaces
- Fireboxes measured against the set's size table
- Burners leveled and centered in the firebox
- Soot problems traced to placement, burner or air
- Inlet pressure read with other appliances running
How gas log installation runs
-
Measure firebox and room
Firebox, chimney height and, for vent-free sets, the room are checked against the manual.
-
Clean and clamp
Soot and debris come out of the fireplace, and vented sets get their permanent damper clamp.
-
Connect and test
Once gas reaches the valve, the set is connected, leak tested and its pressure read.
-
Place logs and light
Logs and embers go where the manual shows, and we light the set with you.
Inherited gas logs in Arlington
Sets inherited with a house in Arlington often come without a manual.
We identify the set from its plate and reset it.
10% off any service booked within 72 hours of inspection
Vented or vent-free logs, the install is discounted either way.
What a vented log set is listed to
Florida's fuel gas code, in section 602.1, covers decorative appliances for installation in approved solid-fuel fireplaces: they must be listed to ANSI Z21.60 and installed according to the maker's instructions. That is the category a vented gas log set falls into.
The listing assumes a working fireplace and chimney, so the set is only as safe as the fireplace it sits in. One vented set's manual limits it to a solid-fuel-burning fireplace with a working flue, built of noncombustible materials. We confirm that before any set is recommended, and the listing is recorded on the ticket.
The oxygen sensing pilot on vent-free logs
Vent-free sets carry an oxygen depletion sensing pilot, which shuts the set off if the room's fresh air runs low. One maker's manual says the heater needs fresh air ventilation to run properly and points to its ventilation section if the set keeps shutting off.
Repeated shutoffs are a message about the room, not a nuisance to work around. We check the room volume, open connections and the house's tightness, and the sensing pilot is left exactly as the maker built it. The same maker notes that running above 4,500 feet of elevation can cause pilot outage. A shutoff after a long burn in a small room is the system doing its job.
What the flame should look like
Vented gas logs are designed to burn with yellow flames. One maker describes its main burner flames as blue at the base with a blue and yellow body and tips, standing roughly 5 to 8 inches above the logs, the center flame tallest, with ember flames about a quarter inch above the embers.
Flames that look very different, lift off the burner or lick the logs heavily point to pressure, placement or air problems. We compare the live flame with the manual's description at the first light and at every service visit. The manual's flame drawing is the reference on every visit.
Measured in Arlington before a log set is ordered
- Front lip or recess measured, with depth taken inside it
- Supply pipe sized by the gas trade, with inlet pressure read at the valve
- Flame compared with the manual's description at first light
- Screen in place, with flames curling in and away from it
Before a log set goes in
Can gas logs go into any fireplace in Arlington?
No. Vented logs need a sound fireplace and a chimney that draws, while vent-free logs need a big enough room where the rules allow them. Both are checked on a free visit.
Are vent-free logs allowed in any room?
No. The fuel gas code limits them by room size and input, and one maker's set may not go in a bedroom or bathroom. Some local rules prohibit them altogether.
More services in Arlington
-
-
-
-
-
-
Learn more about gas log installationAll services in Arlington
A gas log set that fits your Arlington fireplace
A local gas log specialist inspects the damper and chimney in Arlington and quotes in writing.
Free Inspection