Local chimney chase cover replacement for Tallulah-North Shore homes
Chase covers across Tallulah-North Shore in a metal chosen for the exposure, specified by local pros during a free inspection.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Why Tallulah-North Shore trusts local pros with chase tops
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
You get the metal, the gauge and what we found under the old top of your Tallulah-North Shore chase in writing, so any other quote can be compared line by line.
- Free inspection and estimateWe measure your Tallulah-North Shore chase and look under the old top at no charge before anything is quoted.
- Upfront pricing, no hidden feesMetal, gauge and any framing repair each get their own priced line, and that total is what you pay.
- Workmanship warrantyThe new top, its collars and its fasteners are covered by our workmanship warranty, written on the estimate.
Choosing the metal for a chase top
Fireplace manuals give a minimum metal for the chase top, and on one major maker's drawing that minimum is a light galvanized sheet. A minimum is only the floor. A flat sheet that holds any water uses up its zinc coat fast, so for a chase in Tallulah-North Shore our starting proposal is stainless steel in a heavier gauge, with copper where the look matters to the owner. If a painted or coated finish is chosen for color, it is listed too, with a note that the metal underneath is what sets how long the top lasts. Rust spots or a drip under the chase in Tallulah-North Shore mean the top should be checked, and our sheet metal pros do that for free at (904) 920-5495.
Tallulah-North Shore sits in Duval County. Tallulah-North Shore does not reach the coast.
Your chase top job, part by part
- Skirt turned down over the siding, ending in a drip
- Screws set through the skirt sides into the framing
- Framing and sheathing under the old top probed and reported
- Rust streaks on Tallulah-North Shore siding traced to cover, collar or cap
From tape measure to hose test in Tallulah-North Shore
-
Measure over the siding
We measure all four sides at the top of your Tallulah-North Shore chase, over the siding and trim, and check the diagonals so the skirt fits snug.
-
Read the fireplace drawing
The maker's manual for your model sets the collar height, the open gap at the pipe and the minimum slope, and the new top is drawn to it.
-
Shape, collar and fasten
The top is cross-broken or pitched away from each pipe, collared at every hole and screwed through the skirt into the framing. The storm collar goes back on and is sealed where the manual says.
-
Hose test and walk-through
Where the roof gives safe footing, we run water over the finished top and watch it leave every edge, then show you what changed.
Sun and sealant on Tallulah-North Shore chase tops
A chase top in Tallulah-North Shore bakes in full sun for most of the year, and sealant at the storm collar hardens and cracks with that heat. A collar joint that has opened sends rain down the pipe.
We clean off the old sealant and reseal the storm collar with the product and in the places the chimney manual names, and nowhere else.
10% off any service booked within 72 hours of inspection
Mention the discount when you call, and it shows as its own line on the chase cover estimate.
Cross-breaks, the creases that move water
Cross-breaks are shallow creases pressed into the sheet from corner to corner, forming a low X. They do two things. They stiffen a flat panel so it does not sag between its edges, and they give the surface four gentle slopes that fall from the center toward the sides.
On a chase top that means water runs away from the pipe collar and off the drip instead of pooling. Cross-breaks suit tops with the pipe near the center. When the pipe sits off to one side, a top with a fabricated pitch can do the same job more evenly, and we say which shape we will build and why.
Tracing a rust streak to its source
A rust streak on siding points up to its source, but more than one metal part sits at the top of a chase. The cover itself, the storm collar, the termination cap and the fasteners can each rust and streak. The pattern helps: a wide stain starting all along the skirt edge points to the cover, while a narrow streak under one spot may come from a single fastener or from the cap above. We look at each part from the roof and name the source, so a new cover is not sold to fix a rusting cap, and a new cap is not sold to fix a rusting cover.
Checking the top pipe section while it is exposed
With the old cover and the cap off, the top section of the chimney pipe is in plain view. Rust on its outer wall, a dented section, or a loose joint between sections all show clearly at that moment, and they are hard to see at any other time. Damaged chimney pipe is not patched: sections are part of the listed system and are replaced with the maker's parts for that model.
If we see damage, you get the part name and a description of what we saw. If the pipe is sound, the new cover and the cap go back on and the section is covered again.
Checks behind a chase cover price
- Collar height and hole diameter for each chimney pipe
- Storm collar replaced or refitted, sealed where the manual specifies
- Framing and sheathing condition under the old top, priced separately
- Pipe spacing and layout where more than one vent passes through
Chase cover questions from Tallulah-North Shore
Will you replace the cap on the pipe too?
Only if it is damaged, and then with the part the fireplace maker lists for that model. A sound listed cap is reinstalled over the new cover.
What metal do you recommend for a chase top?
It depends on the size of the chase and the exposure. Our starting point is stainless steel in a heavier gauge than the minimum, and the estimate names the grade and gauge.
More services in Tallulah-North Shore
-
-
-
-
-
-
Learn more about chimney chase cover replacementAll services in Tallulah-North Shore
New chase cover, measured on site
Get a written price for your Tallulah-North Shore chase top from a local specialist before anything is cut. Book the free visit by phone or with the form.
Free Inspection