Cracked flue tile repair in Tallulah-North Shore
Top tiles replaced from the roof or joints resurfaced with a listed system, sized so your Tallulah-North Shore fireplace still draws.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Family-owned flue experts serving Tallulah-North Shore
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
When part of the flue cannot be seen, the report says so instead of guessing.
- Free inspection and estimateThe flue at your Tallulah-North Shore home is swept, examined from both ends and mapped at no charge.
- 100% satisfaction guaranteedIf the repaired flue is not sound and correctly sized when we finish, we make it right.
- Family owned and operatedA family business maps the flue and does the repair, so the plan and the work stay in one set of hands.
Tiles disturbed by work at the top
Work at the chimney top can disturb the last tile. A cap clamped too hard, a crown chipped away or a tile knocked while other work was done can leave a crack where there was none.
A top tile is reachable, so this is often a small repair: the tile is replaced or its broken edge cut back, and the seal around it is remade. We check the tile below too, since a knock can travel. Top tile damaged after recent roof or cap work in Tallulah-North Shore? Phone (904) 920-5495 for a free flue inspection.
Tallulah-North Shore is one of the named neighborhoods of Jacksonville. Tallulah-North Shore is part of Duval County.
What a flue repair covers in Tallulah-North Shore
- Seal around the top tile remade
- Loose mortar ridges knocked back inside the flue
- Cure time respected before the first fire
- Flue mapped at your Tallulah-North Shore home before any price is given
How chimney flue repair runs
-
Swept and examined
The flue is cleaned, then looked over from the roof and the firebox with a light and mirrors.
-
Mapped and measured
Each defect is placed by height and wall, and the flue size is checked against what it serves.
-
Repaired by the chosen method
Top tiles swapped from the roof, damaged sections coated with a listed system, or a relining price when repair will not hold.
-
Checked and cured
The finished flue is examined from both ends and left to cure before the first fire.
Gas appliances venting through Tallulah-North Shore chimneys
Some houses vent a furnace or water heater into a masonry flue. The water vapor in those gases condenses in a cool flue and wears at the joints wherever the house is.
We check appliance flues in Tallulah-North Shore for washed-out joints and for a flue size that suits the appliance.
10% off any service booked within 72 hours of inspection
Flue repair earns the 10% off even if you have booked with us before.
Why the code asks for a lined chimney
Section R1003.11 of the Florida residential code requires a lining in every masonry chimney, of a type that suits whatever appliance is connected, as its listing and maker direct. The liner is a separate duct inside the chimney walls, and its job is to carry smoke, gases and condensate up and out without letting them into the brick.
Repair work restores that duct. Whatever method is used, the result has to be a continuous, sealed passage from the bottom of the lining to the top. A repair that closes one crack but leaves an open joint below it has not done the job, which is why the whole flue is examined before any single fix is priced.
The mortar that holds flue tiles
The mortar between flue tiles is its own material. Section R1003.12 names a medium-duty refractory mortar that water will not dissolve, made to ASTM C199, and it wants every joint tight and finished smooth on the flue side. Ordinary masonry mortar or a generic patch is not that material.
When a joint is remade or a tile is reset, the same class of mortar goes back in. Smooth joints matter as much as tight ones, because a ledge of mortar inside the flue catches deposits and slows the gases. The estimate names the mortar used for any tile work, so the repair matches what the code asks for.
How far a flue lining has to run
The lining is meant to run the full height it serves. An appliance flue's lining begins 8 inches or more under its lowest inlet. A fireplace flue's lining begins where the smoke chamber ends. Either way, it finishes above the surrounding chimney walls (R1003.12).
Gaps at either end are common repair points. At the bottom, the first tile may not meet the smoke chamber cleanly. At the top, the last tile may have been cut short or broken back to the crown. We check both ends on every flue, since a sound middle with open ends still lets heat and gas into the masonry.
What goes on the flue map in Tallulah-North Shore
- Every defect located by flue, height and wall on a written flue map
- Top tiles to replace from the roof, with the seal around them remade
- Offsets and bends noted with their height and angle
- Inlet thimble and cleanout door condition on appliance flues
Before a flue repair is chosen
Do you repair chimney flues in Tallulah-North Shore?
Yes. We repair clay flues across Duval County, Tallulah-North Shore included, from single top tiles to full-height resurfacing. If a sweep left a note, have it ready when you call.
Can one cracked tile be fixed on its own?
If it is the top tile, often yes, from the roof. A single cracked tile lower down usually cannot be reached alone, so it is covered by resurfacing that section or by relining, depending on the rest of the flue.
More services in Tallulah-North Shore
-
-
-
-
-
-
Learn more about chimney flue repairAll services in Tallulah-North Shore
Seal the flue in your Tallulah-North Shore chimney
The same family crew that inspects your Tallulah-North Shore flue for free is the one that repairs it.
Free Inspection