Fireplace insert installation for Sawgrass homes
Mantel, hearth and side clearances in Sawgrass measured against the insert's label on a free inspection, before the order is placed.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Local insert pros who install to the listing
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
An insert in Sawgrass goes in only after the fireplace has been measured against the insert's own table.
- Free inspection and estimateYour Sawgrass firebox, chimney height and hearth are measured against the insert's manual at no charge, before anything is ordered.
- Upfront pricing, no hidden feesEvery part of the job is priced before ordering, from repairs to the rain cap, and nothing is added without your yes.
- 100% satisfaction guaranteedIf the insert smokes or draws poorly after installation to its manual, we come back and set it right.
Will an insert fit this fireplace
Every insert manual carries a small table that decides whether the unit fits: the narrowest opening at the front, the width of the back wall, the height and the depth the firebox must offer. Splayed side walls and a shallow back can rule out a model that looks right from across the room.
We take all four measurements at the tightest points and set them beside the table for the model you like, so the fit is settled before you pay for a unit. Considering an insert for the fireplace in your Sawgrass home? Measurements start at (904) 920-5495.
Sawgrass is in St. Johns County. The 2020 Census count for Sawgrass was 5,385 people.
Insert installation for Sawgrass fireplaces
- Fireplace repairs finished before the insert goes in
- Hearth extensions and ember protection where required
- Surrounds sealed or left open per the manual
- Older unlined inserts reconnected to a liner
How our insert pros install a wood insert in Sawgrass
-
Measure against the manual
Firebox, chimney height, hearth and clearances are checked against the insert's table before ordering.
-
Repair and clean first
Fireplace repairs are made and cured, and the flue is cleaned before the liner goes up.
-
Liner, plate and cap
A listed stainless liner runs to the top, closed with a top plate and a rain cap.
-
Set, seal and fire
The insert and surround go in as the manual directs, and the first fire is run with you.
Salt on the top plate in Sawgrass
The top plate that closes the old flue around the liner collects salt with every onshore wind on the coast. The sealant joint at the liner collar is the part to watch.
We note its condition on every visit in Sawgrass and reseal it when it cracks.
10% off any service booked within 72 hours of inspection
An insert for a home in Sawgrass is a larger job, and the discount still applies to all of it.
Closing the top of the old flue
Above the chimney, a full liner ends in a top plate and a rain cap. One maker's instructions have the plate trimmed to fit the existing flue with an overlap of 1 to 1 1/2 inches on each side, seated firmly on the flue lining, screwed to the liner collar and sealed with RTV silicone.
The cap then goes on the end of the liner. The plate keeps rain and animals out of the space around the liner, and the cap keeps them out of the liner itself. Both are listed on the estimate with the liner, and a cracked flue top that the plate would sit on is noted before the work.
Repairs that come before the insert
Inserts sit inside the fireplace, so the fireplace has to hold up around them. Insert guides ask for the masonry to be checked for cracks, loose mortar and other defects, and for repairs to be finished before installation, with the masonry fireplace built to NFPA 211 or the local code.
Open firebox joints, cracked firebrick or a failed throat get fixed first, each priced on its own line, and repairs made in refractory mortar dry for the time on the data sheet before the insert goes in. We schedule the install after that drying time so nothing is rushed.
The door stays closed while it burns
Inserts are built to burn with the door shut. One maker warns that an open door can throw sparks onto nearby materials and makes the heater draw air from the living space, and that anything causing negative pressure in the house can pull fumes into the room.
Exhaust fans, range hoods and a running dryer together can lower the pressure in a tight house. We ask about them on the visit and explain how the insert behaves when they run, so the first smoky moment is understood rather than a surprise. The door gasket is part of the same story, since a worn one leaks air.
Measured in Sawgrass before an insert is ordered
- Fireplace cracks, loose mortar and throat condition repaired before install
- Flue cleaned and checked for obstructions before the liner goes up
- Surround sealed or left open as the manual directs for the air source
- Metal tag fixed to the fireplace back wall when the manual supplies one
Before you order an insert
Can any fireplace in Sawgrass take a wood insert?
No. The fireplace must be at least the size the insert's manual lists, sound or repaired first, with a chimney tall enough and a flue of its own. We check all of it on a free inspection.
Can an insert go into a metal fireplace?
Only where both the insert and the factory-built fireplace allow it. That means meeting the insert maker's extra conditions for metal fireplaces, so we read both manuals first.
More services in Sawgrass
-
-
-
-
-
-
Learn more about wood-burning fireplace insert installationAll services in Sawgrass
Get more heat from the fireplace in Sawgrass
Cold room, open fireplace in Sawgrass? A free visit tells you whether an insert will fit.
Free Inspection