Local gas fireplace installation in Oceanway

The free plan draws the vent route for your Oceanway house, counts each elbow and measures the termination clearances.

Family owned and operated
Free inspection and estimate
Same-day service available
Upfront pricing, no hidden fees

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

or call (904) 920-5495

Why Choose Us

Gas fireplace install specialists for Oceanway

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off when you book today

The vent route is checked against the vent table before any framing starts.

Family owned and operatedOne family business frames, vents and starts up the unit in Oceanway, and lines up the gas and electrical trades.
Free written estimatesThe unit, vent parts, framing, permit and every trade are on one free written estimate.
Workmanship warrantyThe workmanship warranty applies to our venting, framing and start-up, and the unit keeps its maker's terms.

Call (904) 920-5495 Free Inspection

Permit and inspections for a gas installation

Gas fireplaces go in under a permit, pulled before work starts and closed out with a final inspection. In between, an inspector looks at the parts that will be hidden: the gas connection, the vent run with its supports and firestops, and the framing around the unit. For the Oceanway job, those checks are placed in the schedule so no wall is closed early, and the permit is priced as its own line. The inspector checks the work against the unit's manual, so a copy stays with the unit from the first day of work. Natural gas or propane at your Oceanway home? Say which on the call to (904) 920-5495.

More than about six miles separate Oceanway from the coast. Oceanway lies roughly 14 miles from Jacksonville, measured directly rather than by road.

What's Included

From vent exit to first burn

Horizontal runs pitched the way the manual asks
Siding standoff fitted behind a wall termination
Wiring for the receiver and blower run before the wall closes
Permit and inspections for your Oceanway install scheduled

Call (904) 920-5495 Free Inspection

How It Works

How our gas fireplace pros install a unit in Oceanway

Unit and vent route chosen
We pick a listed unit for the room and draw the vent route against the manual's vent table.
Framed and vented to the manual
Framing, header and clearances come from the manual, and the vent is run with its firestops and supports.
Gas and power by their trades
A gas contractor or the propane supplier brings gas to the shutoff valve, and an electrician adds any outlet.
Start-up readings and leak check
Pressures are read at the valve, every joint is leak-checked, the flame is checked and the barrier fitted.

Local Conditions

Bedrooms and B-vent units in Oceanway

A B-vent fireplace takes its air from the room, so the fuel gas code limits it in bedrooms to rooms of a set size. A sealed direct-vent unit avoids that limit.

We check the room size in your Oceanway home before recommending either type.

10% off your first service when you book today

Booking gas fireplace installation in Oceanway today? Your first service with us is 10% off.

Call (904) 920-5495 Free Inspection

Pitching the horizontal runs

The manual says how a horizontal section of vent is pitched, and different systems ask for different things. One system may allow a level run while another asks for a set rise per foot away from the unit, so the figure comes from the manual in hand every time. The pitch decides how exhaust and any condensate move through the pipe. A section that sags or runs back toward the unit can upset the draft and, on some units, put the pilot out.

We set each section with a level and support it at the spacing the manual gives. Pitch is checked again after the wall is closed around it.

The clear zone in front of the cap

The space in front of a wall termination has to stay open so exhaust can disperse and fresh air can reach the intake. Manuals set a clear distance in front of the cap free of shrubs, fences, sheds, decks and other obstructions. A spot that is clear today can be crowded later by a hedge or a new fence, so we point out the zone when the termination goes in and note it for anyone doing landscaping.

Where a guard is needed because the cap sits within reach of people, the vent maker's guard is used. The zone is noted on the plan too.

The first long burn

A new gas fireplace gives off an odor the first time it runs, as the paint and materials cure, so plan on open windows during that burn-off, as the manuals advise. One maker recommends running the unit for an extended period the first time, with the fan switched off. We start that process at handover, open the windows, and tell you what to expect over the first few fires.

An odor that persists after the burn-off, or any smell of gas, is a different matter and a reason to call. Children and pets are best kept out of the room while it happens.

Free Inspection

Checked outside and in before an install in Oceanway

Unit named by maker and model, with its heater or decorative listing
Termination spot measured to windows, soffits, corners and walks
Service access panels left removable after the finish
Inlet and manifold pressures read and recorded at start-up

FAQ

Before the vent hole is cut

Will the vent termination be visible outside?

Yes, a wall termination is a cap on the outside wall at the spot the clearances allow. If the house is under an association, check its rules before the spot is final.

Does a gas fireplace need an electrical outlet?

Units with electronic ignition or a blower do, in the location the manual shows, and an electrician adds it if one is not there. A standing-pilot unit without a blower can run with no house power.

Our Services