Local gas fireplace installation in Oakleaf Plantation
Unit, vent parts, termination spot and start-up checks for your Oakleaf Plantation install, all worked out on a free planning visit.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Local gas fireplace experts for new installs in Oakleaf Plantation
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
The unit, the route and every trade for your Oakleaf Plantation install sit on one written estimate.
- Family owned and operatedOne family business frames, vents and starts up the unit in Oakleaf Plantation, and lines up the gas and electrical trades.
- Workmanship warrantyThe workmanship warranty applies to our venting, framing and start-up, and the unit keeps its maker's terms.
How long a gas installation takes
Setting the unit in its framing is one of the shorter steps in the job. The calendar goes to the steps around it: the unit and vent parts arriving, framing the enclosure, running the vent, the gas contractor's line and any outlet, the inspection while the walls are open, and the finish. A wall exit is quicker to build than a roof exit, which adds attic work and roof covering. Your Oakleaf Plantation schedule shows the steps in order with who does each, so you know when the room is out of use and when it comes back. Picked a room for a gas fireplace in Oakleaf Plantation? (904) 920-5495 is the number for a free planning visit.
Oakleaf Plantation does not reach the coast. Oakleaf Plantation sits in Clay County.
What a gas fireplace installation covers in Oakleaf Plantation
- Vent exit found on the outside wall or roof first
- Horizontal runs pitched the way the manual asks
- Facing and mantel planned from the manual's chart
- Gas line to the shutoff valve assigned to a gas contractor
Vent out, frame, wire, start up
-
Vent exit found first
We find where the vent can leave the house within the manual's clearances, then pick the unit to suit.
-
Frame and run the vent
The enclosure and header are framed to the drawing, and the vent is run with its supports, pitch and firestops.
-
Trades, wiring and gas
Wiring goes in before the wall closes, and the gas contractor brings the line to the shutoff valve.
-
Start-up and inspection
Pressures are read, joints leak checked, the inspector signs off, and we go over the controls with you.
Direct-vent in a room with no chimney in Oakleaf Plantation
A direct-vent unit brings its own coaxial vent, so it needs no chimney. It can exit straight through a wall or up through the roof.
That makes a gas fireplace possible in many Oakleaf Plantation rooms that never had one.
10% off any service booked within 72 hours of inspection
Planning a vented unit? Decide inside the 72 hours and you save 10%.
Distance to windows and doors
The termination of a direct-vent unit has to stay a minimum distance from any window or door that can be opened, so exhaust cannot drift back inside. The distance grows with the unit's input rating in steps set by NFPA 54, and the manual's clearance table repeats them.
A permanently closed window has its own, smaller recommendation in some manuals. We measure from the edge of the termination to the nearest edge of each opening, including windows above and beside it, and mark the spot only when every distance clears. The table also covers doors, including sliding glass doors that open.
Soffits, eaves and porch ceilings
Heat and exhaust rise, so the manual sets how far below a soffit or eave a termination has to sit. A ventilated soffit, with openings that could take exhaust into the attic, needs more distance than a solid one. Porches and decks are handled separately: a termination may sit under a veranda, porch or deck only when it is open on the sides the manual specifies, and at the height it gives. Vinyl soffits can deform from heat, and some makers warn against terminating beneath them.
We check each overhead surface near the chosen spot. The measurements go on the plan.
The first long burn
A new gas fireplace gives off an odor the first time it runs, as the paint and materials cure, so plan on open windows during that burn-off, as the manuals advise. One maker recommends running the unit for an extended period the first time, with the fan switched off. We start that process at handover, open the windows, and tell you what to expect over the first few fires.
An odor that persists after the burn-off, or any smell of gas, is a different matter and a reason to call. Children and pets are best kept out of the room while it happens.
Unit, vent route and trades on paper
- Vent route drawn with each elbow counted against the vent table
- Wall thimble or roof parts from the vent maker's list
- Roof covering around a roof termination, and who patches it
- Inlet and manifold pressures read and recorded at start-up
Gas fireplace install questions from Oakleaf Plantation
Do you run the gas line to the new fireplace?
No. The line to the unit's shutoff valve is a gas contractor's job, or the propane supplier's on a propane system. The estimate says who and when, and start-up follows once gas reaches the valve.
Does the 10% discount cover a gas fireplace installation?
It does, when you book the installation within 72 hours of the free inspection. The written estimate shows the 10% off as its own line.
More services in Oakleaf Plantation
-
-
-
-
-
-
Learn more about gas fireplace installationAll services in Oakleaf Plantation
Add a gas fireplace in Oakleaf Plantation
A direct-vent unit needs a path out through a wall or the roof, and our gas fireplace experts find it on your home in Oakleaf Plantation. Call (904) 920-5495.
Free Inspection