
Local gas fireplace installation in Neptune Beach
Every gas fireplace we install in Neptune Beach ends with the manual, the shutoff location and the lighting steps in your hands, and the planning visit is free.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Gas fireplace installation specialists who vent to the manual
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Start-up includes pressure readings and a leak check, written on your Neptune Beach record.
- Family owned and operatedOne family business frames, vents and starts up the unit in Neptune Beach, and lines up the gas and electrical trades.
- Workmanship warrantyThe workmanship warranty applies to our venting, framing and start-up, and the unit keeps its maker's terms.
Gas fireplaces in bedrooms
The fuel gas code lists bedrooms among the rooms where gas appliances are not allowed, then writes exceptions that cover fireplaces. A direct-vent unit qualifies when it is installed to its listing, since it takes no air from the room. A B-vent unit qualifies only in a room big enough for the code's volume test, which compares the room's cubic footage with the unit's input. For a bedroom in Neptune Beach, we measure the room, take the input from the unit's specifications, and put the arithmetic on the estimate so you can see whether a B-vent model passes or a direct-vent unit is the answer. Ring (904) 920-5495 with the room you have in mind, and our gas fireplace pros will plan the Neptune Beach install on a free visit.
Neptune Beach falls within Duval County. Neptune Beach had 7,217 residents at the 2020 Census.
From vent exit to first burn
- Siding standoff fitted behind a wall termination
- Wiring for the receiver and blower run before the wall closes
- Gas line to the shutoff valve assigned to a gas contractor
- Start-up readings and leak check at the valve
How our gas fireplace pros install a unit in Neptune Beach
-
Vent exit found first
We find where the vent can leave the house within the manual's clearances, then pick the unit to suit.
-
Frame and run the vent
The enclosure and header are framed to the drawing, and the vent is run with its supports, pitch and firestops.
-
Trades, wiring and gas
Wiring goes in before the wall closes, and the gas contractor brings the line to the shutoff valve.
-
Start-up and inspection
Pressures are read, joints leak checked, the inspector signs off, and we go over the controls with you.
Placing the termination on coastal homes in Neptune Beach
Onshore wind on the coast can press against a wall termination. The manual's clearances still decide the spot, and within them we favor a side that is easy to reach for rinsing and checks.
The termination on your Neptune Beach house is placed where you can see it and keep it clear.
10% off any service booked within 72 hours of inspection
From the vent run to the start-up checks, a gas fireplace install in Neptune Beach is 10% off.
Siding, standoffs and heat
Vinyl siding needs protection from a termination's heat, and vent makers supply a standoff or siding shield for it. The standoff holds the termination out from the siding so the cladding is not in contact with hot parts, and the kit instructions say how it is mounted and flashed into the wall.
On brick or stucco, the termination mounts to the wall surface with its own trim. The manuals also require the termination to sit flush with the wall surface rather than recessed into it, so exhaust can clear the wall. Stucco and brick still need the termination sealed to the wall as the kit shows.
Propane tanks and the fireplace
A propane fireplace runs off a tank outside the house, and the manuals are explicit that propane tanks do not go inside any structure. Some manuals set a minimum tank size so the tank can vaporize enough gas to keep up with the unit, which matters on small tanks.
The regulator at the tank and the line to the house belong to the propane supplier. We confirm with the supplier that the tank, regulator and line suit the fireplace's input before the unit is ordered, so start-up is not the first time anyone checks. The supplier's answer is kept with the installation plan.
Choosing termination parts near salt spray
Salt spray speeds up corrosion of exposed steel, and a new vent termination spends its life outdoors. Near the coast, we look at what the vent maker offers for the termination, its trim and its fasteners, including stainless or coated options where the maker lists them, and use those parts on the exterior. The termination is placed where it can be reached for rinsing and inspection, and the manual's clearances still govern its spot. The corrosion-resistant parts chosen are recorded, so they can be matched if anything is replaced later. Rinsing the cap with fresh water now and then slows the salt down.
Checked outside and in before an install in Neptune Beach
- Unit named by maker and model, with its heater or decorative listing
- Framed opening and header height taken from the manual
- Termination spot measured to windows, soffits, corners and walks
- Barrier screen fitted and logs set to the placement diagram
Before the vent hole is cut
Is a direct-vent unit or a B-vent unit better?
It depends on the room and the route. A direct-vent unit is sealed and can exit through a wall, and it is allowed in bedrooms when installed to its listing. A B-vent unit uses room air and needs a vertical vent through the roof.
Does a gas fireplace need an electrical outlet?
Units with electronic ignition or a blower do, in the location the manual shows, and an electrician adds it if one is not there. A standing-pilot unit without a blower can run with no house power.
More services in Neptune Beach
-
Gas Fireplace Venting Direct-vent and B-vent pipe runs, joints and terminations.
-
Chimney Damper Repair and Replacement Stuck, rusted or warped throat dampers and their handles.
-
Chimney Leak Repair Water coming in at the chimney, traced by testing and stopped where it enters.
-
Chimney Tuckpointing Worn, recessed or cracked mortar joints raked out and repointed.
-
Hurricane and Storm Damage Chimney Repair Wind and water damage to caps, covers, crowns, flashing and masonry repaired.
-
Gas Log Installation Vented and vent-free log sets set into sound wood-burning fireplaces.
Learn more about gas fireplace installationAll services in Neptune Beach
A vented gas fireplace for your Neptune Beach room
Your Neptune Beach room and outside wall are checked by a local installer, and the whole job is priced together.
Free Inspection