Local top sealing damper installation in Nassau Village-Ratliff
Order a top sealing damper for your Nassau Village-Ratliff fireplace in the 72 hours after we measure, and a local family business takes 10% off the install.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Top sealing damper specialists in Nassau Village-Ratliff
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
You get a walk-through on opening, closing and locking the lid.
- Free inspection and estimateYour flue tile in Nassau Village-Ratliff is measured and the crown checked on a free visit before any damper is ordered.
- Upfront pricing, no hidden feesThe model, the handle position and any tile or crown work are priced in writing up front.
- 100% satisfaction guaranteedIf the lid does not seal or open the way we showed you, we return and adjust it.
Daylight past a closed damper
Close the damper, lie on the hearth with a flashlight off and look up. If you can see light around the plate, air is moving through the chimney whenever the fireplace sits idle. Metal-on-metal throat dampers leak once they warp or rust. A damper that looks closed from the room can still leave a gap wide enough to feel the draft with your hand.
A top damper closes against a gasket at the top of the flue, which seals far better than a warped plate. We measure your flue tile in Nassau Village-Ratliff, confirm it is sound and write the model and price down before anything is ordered.
Nassau Village-Ratliff had 5,561 residents at the 2020 Census. Nassau Village-Ratliff is an inland community.
Top damper work we take on in Nassau Village-Ratliff
- Lids adjusted to seal on their gaskets
- Cracked tile rims repaired before fitting
- Every flue identified before any fitting
- Your Nassau Village-Ratliff chimney's tile and crown checked first
The order of a top damper install
-
Tile measured on the roof
The flue tile's outside size, height and rim are checked on a free visit, with the crown around it.
-
Model ordered to fit
The damper is chosen from the maker's size chart for your tile and approved on the estimate first.
-
Frame set, cable run
The frame is set in the maker's adhesive, the old plate made safe and the cable run to the handle.
-
Adjusted and demonstrated
The lid is adjusted to seal, and you try the handle before we leave, with the cure time written down.
Sweeping schedules inland in Nassau Village-Ratliff
Fitting a damper does not change the yearly inspection NFPA 211 calls for. In Nassau Village-Ratliff, the flue is still checked, and swept when it needs it, with the lid open.
The gasket, spring and cable get looked at on the same visit.
10% off any service booked within 72 hours of inspection
Two quotes for a top damper? You have 72 hours to compare them and still take 10% off.
Setting the frame in its adhesive
Top damper frames are set on the tile in a high-temperature adhesive supplied with the damper. One maker's instructions call for a continuous 1/4 inch bead of the furnished adhesive and a 24 hour set before the damper is used.
We follow the instructions for the model we fit, clean the tile rim first and press the frame down evenly so the bead is continuous. The cure time goes on the ticket, and the fireplace stays unlit until it has passed. Adhesive squeezed out along the joint is tooled into a neat fillet so water runs off rather than sitting against the frame.
Top dampers in strong wind
A closed lid held by its cable sits tight on its frame in wind. An open lid is held up by its spring, and flying debris can strike it or bend its hinge.
After a storm, a quick check of the lid from the ground shows whether it still sits square. If it does not, we straighten or replace the lid and check the frame's bond to the tile. Lids that stay open for long periods between uses catch more debris, so closing the damper between fires helps it last.
Top dampers and chimney plugs compared
An inflatable plug or a draft stopper closes the flue from below and has to be taken out before a fire. A top damper closes the flue from above and opens with its handle. Either can be left closed by mistake, and neither should be.
A top damper's handle sits in the firebox, where it is hard to miss before lighting, and it seals the whole flue from the weather. We explain both options, and fit the damper where it suits how you use the fireplace. Some owners keep a plug as well as a top damper; the plug still has to come out before a fire.
What we check before fitting a top damper in Nassau Village-Ratliff
- Flue tile outside dimensions measured and the model chosen to fit
- Tile height above the crown checked against the maker's minimum
- Tile rim and crown checked, with any repair priced first
- Cable routed clear of tile joints and old damper edges
Before the damper is ordered
Do I still need a chimney cap?
On a single fireplace flue, the open lid sheds rain like a cap, so one may not be needed. Other flues, or a wish for a spark screen, can still call for one, and we explain it on the estimate.
What happens to my old damper?
It is removed or fixed fully open so it cannot close across the flue. The ticket records which.
More services in Nassau Village-Ratliff
-
-
-
-
-
-
Learn more about top-sealing damper installationAll services in Nassau Village-Ratliff
Measure, order, set, adjust, done
Top dampers in Nassau Village-Ratliff are fitted by a local, family-owned crew and covered by our 100% satisfaction guarantee.
Free Inspection