Family-run gas log installation in Nassau Village-Ratliff

Your Nassau Village-Ratliff gas log set priced part by part, with the gas line named for the gas trade and no hidden fees.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Gas log pros who measure first in Nassau Village-Ratliff

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Every log is set to the manual's photos, so the flame stays clean.

Free inspection and estimateYour Nassau Village-Ratliff firebox, flue, damper and room are measured against the set's manual at no charge before anything is bought.
Upfront pricing, no hidden feesSet, burner, clamp, cleaning and any repairs are priced in writing, with the gas trade's part named.
100% satisfaction guaranteedIf the flame is sooty or the set will not stay lit after our installation to the manual, we come back.

Call (904) 920-5495 Free Inspection

A fireplace with a raised lip

Some fireplaces have a raised edge or a step at the front of the firebox floor. Burners are built to sit flat and deep enough in the firebox, and a tall lip can rule some of them out. A raised edge also changes how far into the firebox a burner can sit.

Details like that are why the measuring comes before the buying. Fireplace in Nassau Village-Ratliff with a raised front edge? Have it measured free at (904) 920-5495.

Nassau Village-Ratliff sits away from the coastline. Nassau Village-Ratliff lies within Nassau County.

Gas log work for Nassau Village-Ratliff fireplaces

Fireboxes measured against the set's size table
Logs, embers and media placed to the manual
Cracked logs replaced from the set's parts list
Yearly service set up from install day

Call (904) 920-5495 Free Inspection

From wood fireplace to gas logs in Nassau Village-Ratliff

Measure firebox and room
Firebox, chimney height and, for vent-free sets, the room are checked against the manual.
Clean and clamp
Soot and debris come out of the fireplace, and vented sets get their permanent damper clamp.
Connect and test
Once gas reaches the valve, the set is connected, leak tested and its pressure read.
Place logs and light
Logs and embers go where the manual shows, and we light the set with you.

Room size and vent-free logs in Nassau Village-Ratliff

Rooms in Nassau Village-Ratliff homes come in every size, and vent-free logs follow the code's volume limit.

We measure the room before recommending a set.

10% off any service booked within 72 hours of inspection

Gas log installs in Nassau Village-Ratliff come 10% off, with the logs placed to the maker's diagram.

Call (904) 920-5495 Free Inspection

Unvented logs and metal fireplaces

Code section 621.7 keeps an unvented decorative room heater out of a factory-built fireplace unless the fireplace system has been tested, listed and labeled for that use under UL 127.

One vent-free maker allows its set in a masonry fireplace or a UL 127 factory-built fireplace, but not in a factory-built unit whose own instructions say it was not tested for, or should not be used with, unvented gas logs. The fireplace's own plate and instructions are read before any vent-free set goes into a metal unit. A metal fireplace that rules vent-free out may still take a vented set its manual allows.

Sizing the supply pipe

A log set at full flame needs a steady flow of gas. One maker calls for the supply pipe to be sized to deliver the minimum inlet pressure at the maximum flow rate, with an inside diameter of at least half an inch, and warns that a run longer than 20 feet may need a larger line, referring to NFPA 54.

Pipe sizing and installation belong to the gas trade. We give them the set's input and pressure figures, and check the result at the valve once gas arrives. Other appliances on the same line are taken into account too.

Glass doors and a gas log set

Wood fireplace doors and gas logs need care together. Log set manuals call for glass doors to be fully open whenever the burner runs, and one maker requires any door frame that blocks air along the fireplace floor to have slots above the floor for ventilation.

The same maker measures the fireplace opening with the doors fully open against its minimum size table. We check the doors and frame during the measuring visit, and where the frame blocks air, we write down what it needs before the set goes in. Closed doors in front of a running set are one of the quicker ways to crack glass or overheat a frame.

Firebox, room and damper on paper

Front lip or recess measured, with depth taken inside it
Room use and local rules checked before vent-free is chosen
Damper clamp fitted permanently and the opening measured
Set, gas, clamp and readings recorded on the ticket

Gas log questions from Nassau Village-Ratliff

Are vent-free logs allowed in any room?

No. The fuel gas code limits them by room size and input, and one maker's set may not go in a bedroom or bathroom. Some local rules prohibit them altogether.

Do you replace cracked gas logs?

Yes, with the set's own replacement logs placed to the manual. Call (904) 920-5495 with the set's model for your Nassau Village-Ratliff fireplace.