Local gas fireplace installation for Mayport homes

Natural gas or propane, a free visit plans the Mayport install, which ends with pressures read, connections leak-checked and the barrier fitted.

Family owned and operated
Free inspection and estimate
Same-day service available
Upfront pricing, no hidden fees

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

or call (904) 920-5495

Why Choose Us

Gas fireplace install specialists for Mayport

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off when you book today

We hand over the manual and show you the controls before we leave.

Family owned and operatedOne family business frames, vents and starts up the unit in Mayport, and lines up the gas and electrical trades.
Free written estimatesThe unit, vent parts, framing, permit and every trade are on one free written estimate.
Workmanship warrantyThe workmanship warranty applies to our venting, framing and start-up, and the unit keeps its maker's terms.

Call (904) 920-5495 Free Inspection

See-through and corner units

Not every gas fireplace has one face. See-through units open into two rooms, corner units show two sides of the flame, and some models show three. Each design has its own framing drawing, clearances on more than one side and its own vent options, and a see-through unit's framing has to work from both rooms.

We review the drawing with you in both Mayport rooms, confirm the vent can leave from where the unit sits, and note any finish that has to be matched on both faces. Both faces also need the barrier screen and service access the manual calls for. Natural gas or propane at your Mayport home? Say which on the call to (904) 920-5495.

Mayport lies within Duval County. Kathryn Abbey Hanna Park is in Mayport.

What's Included

Gas fireplace installs around Mayport

Direct-vent or B-vent unit chosen for the room
Heater or decorative listing matched to your plan
Vent route drawn and checked against the vent table
Siding standoff fitted behind a wall termination

Call (904) 920-5495 Free Inspection

How It Works

From vent exit to first burn in Mayport

Unit and vent route chosen
We pick a listed unit for the room and draw the vent route against the manual's vent table.
Framed and vented to the manual
Framing, header and clearances come from the manual, and the vent is run with its firestops and supports.
Gas and power by their trades
A gas contractor or the propane supplier brings gas to the shutoff valve, and an electrician adds any outlet.
Start-up readings and leak check
Pressures are read at the valve, every joint is leak-checked, the flame is checked and the barrier fitted.

10% off your first service when you book today

Booking gas fireplace installation in Mayport today? Your first service with us is 10% off.

Call (904) 920-5495 Free Inspection

Siding, standoffs and heat

Vinyl siding needs protection from a termination's heat, and vent makers supply a standoff or siding shield for it. The standoff holds the termination out from the siding so the cladding is not in contact with hot parts, and the kit instructions say how it is mounted and flashed into the wall.

On brick or stucco, the termination mounts to the wall surface with its own trim. The manuals also require the termination to sit flush with the wall surface rather than recessed into it, so exhaust can clear the wall. Stucco and brick still need the termination sealed to the wall as the kit shows.

Wiring before the wall is closed

Remote receiver, wall switch and blower wiring are run before the finish goes on, as the manuals ask, because running it afterward means cutting into the new wall. A millivolt wall switch needs its own low-voltage wire to the valve, sized and limited in length as the manual shows.

A blower or an electronic-ignition unit needs an outlet in the location the manual gives, added by an electrician. We rough in the low-voltage wiring during framing and confirm the outlet is in place before the drywall goes up. The wire runs are labeled at both ends for whoever services the unit later.

The volume rule for B-vent units

A B-vent fireplace takes its combustion air from the room, so the fuel gas code limits where it can go. In a bedroom, it is allowed only when the room has at least 50 cubic feet of volume for each 1,000 Btu per hour the unit burns, the code's standard method.

A small bedroom can fail that test with a modest unit. A direct-vent unit, which takes all its air from outside, is not held to the same volume rule when installed to its listing. We do the arithmetic from the room's measurements before recommending either. Ceiling height counts, so a tall room holds more volume than its floor area suggests.

Free Inspection

Unit, vent route and trades on paper

Vent route drawn with each elbow counted against the vent table
Roof covering around a roof termination, and who patches it
Noncombustible facing and mantel height checked against the charts
Gas supply to the shutoff valve, named with the trade that runs it

FAQ

Gas fireplace install questions from Mayport

Can I choose the tile or stone around the fireplace?

Yes, within the manual's rules. Only noncombustible materials may cover the metal face, set with the adhesive rating the manual gives, and a mantel follows the manual's chart.

Does the first-service discount cover a gas fireplace installation?

It does, when the installation is your first job with us. The written estimate shows the 10% off as its own line.

Our Services