Local firebox repair for Kings Ferry homes

Upfront pricing on Kings Ferry firebox repair once a free inspection has marked every failed brick and joint.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Firebox specialists who test every brick in Kings Ferry

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

As a family-owned local crew, we show you the failed bricks in Kings Ferry before quoting.

Free inspection and estimateEvery wall of the firebox in Kings Ferry is tapped and probed cold, and the failed bricks and joints are marked at no charge.
Upfront pricing, no hidden feesEach wall is quoted for what it needs, a few joints, a few bricks or a full reline, so a small repair stays small.
100% satisfaction guaranteedIf a joint we repointed opens again after it has cured and been used as the ticket says, we come back and redo it.

Call (904) 920-5495 Free Inspection

Selling a house with a working fireplace

A buyer's inspector looks into the firebox with a light, and open joints or cracked brick show up in the report. Repairing the firebox before listing puts a finished item in front of them instead of an open question and a request for credit.

We write the repair up in plain terms, with the materials named, so the record can go into the listing file, with the date of the work. The repair carries our workmanship warranty. Getting a house in Kings Ferry ready to list? A free firebox check can be booked at (904) 920-5495.

The county for Kings Ferry is Nassau County. Kings Ferry is inland.

What firebox repair covers in Kings Ferry

Hollow-sounding bricks reset in a full mortar bed
Flaking brick faces measured against the code thickness
Rumford fireboxes relined to their original angles
Each wall of your Kings Ferry firebox priced on its own line

Call (904) 920-5495 Free Inspection

Tap, probe, repair, cure

Keep the firebox cold
Let the fireplace go unused for several hours ahead of our visit, so each wall is cool to the touch.
Tap, probe and mark
Each brick is sounded, each joint probed, and the failed ones marked and written up by wall.
Rake, rebrick or reline
Joints are raked and repointed, failed bricks replaced and worn walls relined in C199 mortar.
Cure date on the ticket
The mortar maker's drying time sets the date of the first small fire, written down before we leave.

Rusty grates inland in Kings Ferry

Grates and dampers rust inland too, from rain down the flue and moisture in the chimney, only more slowly than on the coast. A rusted grate that sags lets the fire sit against the back wall.

We note the grate when it is wearing the lining in your Kings Ferry fireplace.

10% off any service booked within 72 hours of inspection

The firebox check in Kings Ferry is free, and the discount lands on the repair that follows.

Call (904) 920-5495 Free Inspection

The eight-inch and ten-inch firebox walls

Section R1001.5 sets the firebox walls by thickness. Where the firebrick lining is 2 inches thick or more, the back and side walls must be at least 8 inches of solid masonry counting the lining. Without a lining, the walls need 10 inches of solid masonry.

A lining worn thin is therefore more than a cosmetic problem, because the credit for the lining depends on its thickness. When we assess a worn wall, we compare what remains with those figures and write down whether new firebrick restores the wall or whether the backing masonry needs attention as well. That comparison is on the estimate in plain numbers.

Full firebrick or thin splits

Firebrick comes in more than one thickness. A full-size brick is commonly 9 by 4 1/2 by 2 1/2 inches, while a split has the same face size at about 1 1/4 inches thick and is made to line stoves and inserts.

Inside a masonry firebox the difference matters. The code credits the lining toward an 8-inch wall only when the lining is at least 2 inches thick, and a split alone falls short of that. When a wall is relined, we choose the brick thickness against that figure and the space available in the firebox, and the estimate states which brick is used and why.

The sloped back of a firebox

In a conventional firebox the side walls and the lower part of the back are vertical, and above that the back leans forward toward the opening. The Brick Industry Association describes the slope as the support for the damper and the flue lining above, and recommends a flat plane over a curve, which reflects more heat into the room.

When we reline or rebuild the back wall, the slope goes back at the angle it had, with new firebrick cut to the line. A back wall rebuilt straight up changes how the fireplace draws and how much heat it sends out, so the angle is measured before the old brick comes out.

Walls, joints and cure time in writing

Each firebox wall and the floor tapped, probed and marked in chalk
Cracked or hollow firebrick cut out and replaced one at a time
Firebox depth measured before any relining is planned
Smoke chamber, damper and hearth items kept on their own lines

Firebox repair questions from Kings Ferry

Will new firebrick match the old color?

Close, though not exact. Firebrick color varies by maker and batch, and the old lining has darkened with use, so new bricks look lighter at first. We tell you before ordering.

Is the inspection really free?

Yes. The firebox check and the written estimate cost nothing, and the pricing is upfront with no hidden fees. Book the repair within 72 hours of the check and 10% comes off.