Cracked flue tile repair in Kings Ferry
Book within 72 hours of the inspection, and your Kings Ferry flue repair with our local crew takes 10% off.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Local flue pros for Kings Ferry chimneys
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Appliance flues are repaired to suit the appliance, with the gas work left to a gas contractor.
- Free inspection and estimateThe flue at your Kings Ferry home is swept, examined from both ends and mapped at no charge.
- 100% satisfaction guaranteedIf the repaired flue is not sound and correctly sized when we finish, we make it right.
- Family owned and operatedA family business maps the flue and does the repair, so the plan and the work stay in one set of hands.
A sweep's note about cracked tiles
Many flue repairs start with a sweep who finished cleaning and found something behind the soot: a crack running up a tile, a joint with the mortar gone or a corner broken off. The note may be short, and it may leave you unsure how serious it is.
We start from that note. The flue is looked over again from top to bottom, each defect is placed by height and wall, and you get a repair path for the whole flue rather than for one crack. Sweep flagged your flue in Kings Ferry? Call (904) 920-5495 and our flue specialists will check it for free.
Kings Ferry is in Nassau County. The coastline lies beyond Kings Ferry.
Tile, joint, seal and size
- Cracked and gapped sections coated with a listed resurfacing system
- Seal around the top tile remade
- Inlet thimbles and cleanout doors checked on appliance flues
- Flue mapped at your Kings Ferry home before any price is given
How our flue pros repair a flue in Kings Ferry
-
Swept and examined
The flue is cleaned, then looked over from the roof and the firebox with a light and mirrors.
-
Mapped and measured
Each defect is placed by height and wall, and the flue size is checked against what it serves.
-
Repaired by the chosen method
Top tiles swapped from the roof, damaged sections coated with a listed system, or a relining price when repair will not hold.
-
Checked and cured
The finished flue is examined from both ends and left to cure before the first fire.
Flues that were built with open joints in Kings Ferry
Some flue gaps come from how the tiles were laid, with little mortar between them. That is a construction question, not a location one.
We find those joints in Kings Ferry flues after sweeping and price the resurfacing or relining that closes them.
10% off any service booked within 72 hours of inspection
Flue repair earns the 10% off even if you have booked with us before.
Heat cracks in clay tile
Clay tile tolerates steady heat better than sudden heat. When a very hot fire meets a cold flue, the inner face of the tile grows faster than the outer face, and the tile can split along its length.
These cracks tend to run vertically and can repeat in tile after tile along the hottest stretch of the flue. A single hairline split in an otherwise sound flue can be resurfaced. Several split tiles, or splits that have opened wide enough to move, point to relining. The flue map shows how many tiles are affected and how far up the damage runs.
Why a generic patch is not a flue repair
R1003.11.1 limits flue linings to four kinds: clay tile made to ASTM C315, lining systems carrying a UL 1777 listing, factory-built chimney sections whose listing allows installation within masonry, and other approved materials able to take flue gases and condensate up to 1,800 degrees Fahrenheit without corroding, eroding, softening or cracking.
A tube of fireplace patch or a bag of masonry mortar pushed into a crack from above meets none of those. It may hide the crack, but it does not restore a lining. So a flue repair from us means new tile bedded in refractory mortar, or a resurfacing system with its listing, and the estimate says which one.
Checking the flue once the repair is done
Finished work is checked from both ends of the flue. Replaced tiles are examined for alignment and smooth joints. A resurfaced flue is examined for full coverage, with no crack or joint left showing, and the coat is left to cure for the time its system specifies before any fire.
The flue size is measured again after resurfacing, to confirm it still meets what the fireplace or appliance needs. The results go on the invoice with the method and materials used, so the next yearly inspection has a record of what was done and where.
What goes on the flue map in Kings Ferry
- Offsets and bends noted with their height and angle
- Gaps at the smoke chamber and at the top end of the lining
- Sections that could not be seen, and the access they need
- Waiting time before a fire, per the mortar or coat maker
Before a flue repair is chosen
When can I light a fire again once the flue is fixed?
After the mortar or resurfacing coat has cured for the time its maker specifies. The estimate gives that time, and we confirm the flue is clear before you light the first fire.
What does a flue inspection in Kings Ferry cost?
The inspection is free, and the flue map with every defect and its price comes with it. Book the repair within 72 hours and you save 10% on it.
More services in Kings Ferry
-
-
-
-
-
-
Learn more about chimney flue repairAll services in Kings Ferry
A flue that carries the smoke out of your Kings Ferry home
Our satisfaction guarantee covers the flue work we do in Kings Ferry, tile by tile and joint by joint.
Free Inspection