Local ventless gas fireplace repair in Hilliard

From a clicking igniter to a sooty mantel, Hilliard ventless fireplace repair begins with a no-charge visit.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Vent-free experts who never bypass a safety shutoff

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Manuals are tracked down for units that arrived without one.

Free inspection and estimateThe rating plate, the room and the flame of your unit in Hilliard are checked on a free visit.
Upfront pricing, no hidden feesCleaning, listed parts and labor are priced in writing before anything is ordered or fitted.
100% satisfaction guaranteedIf the unit does not run the way we said after our service, we come back and put it right.

Call (904) 920-5495 Free Inspection

A vent-free unit that shuts itself off

A ventless fireplace that lights, runs for a while and then goes out can be its oxygen depletion sensor doing its job, or doing it too early. Lint, dust or pet hair at the pilot's air opening can make the sensor trip with plenty of air in the room. A unit that shuts off early is telling you something, and relighting it again and again is not the answer.

In Hilliard, we clean the sensor pilot as the manual describes, check the room it heats and watch the flame through a full run. If cleaning does not cure it, the listed pilot assembly is priced before it is ordered. The inspection is free.

The coastline lies beyond Hilliard. Hilliard is in Nassau County.

What our crew checks and fixes on ventless units in Hilliard

Listed ODS pilot assemblies replaced
Cracked or missing logs replaced with the maker's logs
Soot problems traced to their cause
Your vent-free unit in Hilliard read from its rating plate

Call (904) 920-5495 Free Inspection

The order of a ventless fireplace service

Rating plate and gas confirmed
The model, gas, listing and input are read and the gas confirmed at the valve before parts are ordered.
Room measured against the code
The room volume and every unvented input in it are compared with the code and the manual.
Pilot, burner and logs serviced
The sensor pilot and burner are cleaned, the logs set to the diagram and worn parts replaced.
Leak checked and run through a cycle
Opened joints are leak checked, the flame is watched through a full cycle and findings are written down.

Candles and residue indoors in Hilliard

Soot on the walls near a vent-free unit in Hilliard can come partly from candles or other products used in the room, which makers warn about. The coast has no part in that.

When soot appears, the room is checked as well as the flame.

10% off any service booked within 72 hours of inspection

Unit shutting off? Its service is 10% off when you book it inside three days of our look.

Call (904) 920-5495 Free Inspection

Leak checks after every repair

Any gas connection opened during service is tested before the unit is returned to use. The National Fuel Gas Code calls for leak checks with a leak-detection solution or an instrument, and rules out matches, candles or any open flame for the purpose.

We test each fitting we touched at operating pressure and write down that it was checked. A leak found upstream of the appliance's shutoff is named for the gas utility or a gas contractor. A leak found is fixed and rechecked before the unit is lit.

Damper open or closed

In a masonry fireplace, the damper may stay closed under a vent-free set only where the manual allows it, for example when the surroundings are noncombustible and the mantel clearances are met. Where those conditions are not met, the manual has the damper open and the set runs vented.

The fireplace is checked against those conditions, and the damper is fixed in the position the manual requires. The reason is written on the ticket, so nobody changes it later without knowing why. A damper clamp or stop keeps the damper where the manual requires, so it cannot be moved by accident.

Sets listed for two ways of running

Some log sets carry two listings, as vent-free heaters under ANSI Z21.11.2 and as vented decorative appliances under ANSI Z21.60. Run vented, they need the damper open, and one manual says the thermostat function must not be used in that mode.

Label and manual together confirm which way your set is being run and that the setup matches it. A mismatch is corrected, or written up if it needs your decision. The label on the set shows both listings when it has them.

What we check on a vent-free unit in Hilliard

Adjoining space counted only where the manual allows it
Sensor pilot cleaned by the manual's method, flame shape checked
Inlet and manifold pressure measured against the rating plate
Mantel height and depth checked against the clearance chart

Before the unit is lit again

Why is there soot on my wall?

Logs out of place, flame touching the logs, a dirty burner, drafts or candles in the room are the usual sources. We check each one and fix the cause before the wall is cleaned.

What does your satisfaction guarantee cover on vent-free service in Hilliard?

The service and parts we quote. If the unit does not run the way we said it would after our work, we come back and put it right.