Local chimney waterproofing in Green Cove Springs
Breathable silane or siloxane repellents for Green Cove Springs chimneys, applied the way the data sheet says once a free inspection clears the brick.
- Family owned and operated
- Free inspection and estimate
- Same-day service available
- Upfront pricing, no hidden fees
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
or call (904) 920-5495
Why Choose Us
Chimney waterproofing specialists who test before spraying
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off when you book today
Treatment day in Green Cove Springs is set by the weather window on the product's data sheet.
- Free inspection and estimateWe splash test your Green Cove Springs chimney at no charge and tell you if the brick needs treatment at all.
- No hidden feesRepairs and repellent are separate lines, and nothing is added once the spraying starts.
- 100% satisfaction guaranteedIf treated brick still soaks up water where we sprayed, we come back and put it right.
Protecting your house during treatment
Overspray is the main risk to the rest of the house during treatment. Silane and siloxane products react with glass that is left uncovered, and the maker of our product also asks for paint, plants and asphalt-based materials to be kept clear.
At a house in Green Cove Springs we cover nearby windows, skylights and glass doors, shield the roofing around the chimney, and protect siding, decks and plants below. Any overspray on a surface that was not covered is washed off at once with soap and water, as the directions say. You hear about each of those steps before the day, so you know what to expect. The brick and water check in Green Cove Springs costs nothing; phone (904) 920-5495 to set a day.
Clay County Historic Courthouse is located in Green Cove Springs. Counted as a direct line, Jacksonville and Green Cove Springs are roughly 20 miles apart.
What's Included
Test, repair, then treat
- Crown, cap and flashing checked for openings first
- Test patch left to dry beside untreated brick
- Coverage kept to the maker's rate, never heavier
- Splash test shown to you when the Green Cove Springs job is done
How It Works
How chimney waterproofing runs
-
Water test on brick and joints
We wet the faces and watch where the brick drinks, and check the crown, cap and flashing for openings.
-
Openings repaired, then cured
Joints, brick, crown and flashing are fixed first, and the data sheet's cure time runs before any treatment.
-
Test patch, then a flood coat
A patch shows how your brick takes the product. Then it goes on from the bottom up with a low-pressure sprayer, wet on wet.
-
Splash test and paperwork
Treated brick should bead water and stay light. You get the product, the faces treated and the cure time in writing.
Local Conditions
Hurricane season rain on Green Cove Springs chimneys
Hurricane season, June through November, brings long, heavy rains to inland chimneys too. Brick that absorbs water on the weather side can stay damp for days.
After repairs, a breathable repellent on those faces cuts how much water gets in while still letting the wall dry.
10% off your first service when you book today
Book chimney waterproofing in Green Cove Springs today and take 10% off your first service.
Temperature limits on the data sheet
Clear repellents cure through a chemical reaction, and heat and cold both change how that reaction goes. The product's directions set the window at 40 to 100 degrees Fahrenheit for both the surface and the air, holding for three hours after application, and BIA gives a similar typical range for brick coatings. A chimney face in full sun can run well above the air temperature, so on a hot day the work may be timed for the morning or started on the shaded faces first. The same timing keeps the product from flashing off before it has soaked in properly.
Protecting windows, skylights and shingles
Silane and siloxane products react with unprotected glass as well as brick, as BIA's note points out, and the note adds that these chemicals can etch glass. The maker of the product we apply adds paint, plants and asphalt-based materials such as roof shingles to the list of things to keep clear. So before any spraying, the glass in windows, skylights and doors close to the stack is covered, the roof surface around it is shielded, and plants below are protected as the directions describe. Any overspray that reaches an uncovered surface is washed off with soap and water straight away.
What the treated brick looks like
Once cured, a penetrating treatment is meant to leave the chimney looking much as it did before. The product's own literature describes little or no gloss and no change to natural color or texture, while noting that dense surfaces can darken slightly and that existing stains may become more visible. BIA adds that a noticeable sheen after treatment can mean the wrong product or poor application. The trial area is therefore judged dry, in daylight, from the ground as well as up close, and compared with untreated brick next to it before the rest of the stack is done.
Free Inspection
Tested before any repellent goes on in Green Cove Springs
- Joint, brick, crown and flashing repairs listed before any treatment
- Product name and type: silane, siloxane or a blend of the two
- Faces treated, and surfaces left out such as the crown top
- Stucco or stone areas, and the product listing that covers them
FAQ
Before any sealer goes on
Can the treatment be done the same day as repointing?
No. Fresh joints need at least 72 hours to cure first, according to BIA and the product's data sheet, so treatment is a second visit.
Does the repellent change the color of the brick?
The product we use leaves little or no shine, though very dense brick can go a shade darker. You see the trial patch dry, next to untreated brick, before the rest is done.
Our Services
More services in Green Cove Springs
-
-
-
-
-
-
Learn more about chimney waterproofingAll services in Green Cove Springs
Find out if your Green Cove Springs brick needs sealing
Family-owned masonry professionals check whether your brick in Green Cove Springs needs treatment at all. The test is free.
Free Inspection