Gas insert fireplace installation in Springfield
Co-linear or co-axial, the liners for your Springfield insert follow the maker's rise and offset limits, checked on a free visit.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Local gas insert specialists who install to the listing
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Pressures are read at the valve and joints leak tested once gas arrives.
- Free inspection and estimateThe opening, flue and mantel of your Springfield fireplace are measured against the insert's plate at no charge.
- Upfront pricing, no hidden feesInsert, vent kit, surround, cleaning and repairs are priced line by line, and the gas and power trades are named.
- 100% satisfaction guaranteedIf the insert does not light, burn or seal the way its manual describes after our installation, we come back.
A carbon monoxide alarm near the insert
Carbon monoxide comes with burning gas, and a sealed insert is built to send all of it outside. An alarm in the room still makes sense as a backstop, and one insert maker suggests one alongside yearly service. Headaches, dizziness or nausea while the insert runs mean everyone leaves the house and 911 gets the call from the driveway.
We suggest a spot for the alarm on install day, and every later service visit checks the vent and the seal. Adding a gas insert to a home in Springfield with no CO alarm near the fireplace? Mention it when you book at (904) 920-5495.
Springfield lies inland. Hogan's Creek park system lies within Springfield.
Gas insert work for Springfield fireplaces
- Mantel clearances checked for height and depth
- Surrounds sized to uneven fireplace faces
- Barrier screens and relief doors checked
- Model and vent kit recorded for your Springfield house
How our gas insert pros install an insert in Springfield
-
Measure against the plate
Opening, flue and mantel are checked against the insert's rating plate and manual.
-
Clean and check the chimney
The old flue is cleaned, examined and repaired if needed before the liners go up.
-
Liners, insert, surround
The vent kit runs to its termination, the insert is set and the surround fitted.
-
Hookups and first light
The gas and electrical hookups are made, then we light and test the insert with you.
Natural gas or propane in Springfield
Some homes in Springfield have natural gas and some run on propane. The insert is ordered for the gas the house has.
The supplier is booked alongside the install.
10% off any service booked within 72 hours of inspection
Quote the 10% off when you order the gas insert, and it shows as its own line.
Ignition and the flame safeguard
Under section 602.2 of the fuel gas code, the main burner must be lit by a pilot, an igniter or direct ignition, and a flame safeguard has to prove the flame. The safeguard shuts the gas off if the burner or pilot is not proven lit.
On install day we watch that sequence work: the pilot or igniter lighting, the burner catching and the safeguard holding the valve open only while there is flame. One maker describes a light-up of 5 to 10 seconds across all burner openings as satisfactory, and a slow or patchy light-up is corrected before we leave.
Restrictors and when they apply
Direct-vent systems sometimes use a restrictor, a plate that narrows the exhaust to balance the draft for a given vent height and length. One maker's co-linear sheet states that a restrictor is not required when using its co-linear venting.
Other vent layouts, such as tall co-axial runs, may call for one set to a position in the vent table. We follow the insert's own vent instructions on this point rather than a habit from another brand, and the ticket records whether a restrictor was fitted and at which setting. A restrictor fitted where the kit does not call for one can starve the flame, so this detail matters.
A carbon monoxide detector nearby
Exhaust from a direct-vent insert is designed to leave the house entirely, yet its maker still advises a CO detector in that room plus regular service.
A detector near the fireplace is a small cost next to what it protects against, and we point out a sensible spot when we install. If an alarm ever sounds or someone feels headachy or dizzy while the insert runs, everyone leaves the house, 911 is called from outside, and the insert stays off until it has been checked. We test the alarm's position with you rather than leaving it in a box.
Measured in Springfield before a gas insert is ordered
- Fireplace opening width, height and depth against the insert's plate
- Co-linear or co-axial kit chosen from the insert's manual
- Termination and flashing at the chimney top, with the top checked first
- Model, vent kit and liner sizes recorded on the ticket
Before you switch to gas
Will the insert work in a power outage?
Some models light and adjust on batteries while the blower stays off; others need house power. We check the model you are considering before you buy.
Does a gas insert need yearly service?
Yes. Makers want a yearly check of the insert and its venting by someone qualified, and we can put that on the calendar from the day it goes in.
More services in Springfield
-
-
-
-
-
-
Learn more about gas fireplace insert installationAll services in Springfield
A gas insert that fits your Springfield fireplace
Gas inserts we fit in Springfield follow their manuals line by line, and our satisfaction guarantee covers the result.
Free Inspection