Chimney rebuild in Ortega by local masonry pros

Loose courses above the roof, a lean, or repairs that keep failing? After a free inspection we rebuild the Ortega stack from sound brick up.

Family owned and operated
Free inspection and estimate
Same-day service available
Upfront pricing, no hidden fees

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

or call (904) 920-5495

Why Choose Us

Rebuild specialists who test every course in Ortega

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off when you book today

The finished chimney in Ortega is measured against the code's height rule before the crown is cast.

Family owned and operatedOur family business takes your Ortega chimney down by hand and lays it back up itself.
Upfront pricing, no hidden feesThe take-down line, flue plan and crown are priced before the first brick comes off.
Workmanship warrantyFrom the new courses to the counterflashing, the rebuilt stack carries our workmanship warranty.

Call (904) 920-5495 Free Inspection

What the rebuild estimate lists

Each part of a rebuild is its own line: the take-down height, brick and mortar, the flue work, the crown, the flashing and any cricket, roof protection and debris removal, and permit handling. Reused brick and new brick are shown separately, which tells you how much of the original stack goes back.

Anything uncertain until the masonry is opened is named as an allowance with its reason instead of being hidden in a total. It also states the cure time the Ortega schedule allows before first use. Questions about any line are answered before you sign. Tell us what you see from the ground; (904) 920-5495 reaches our rebuild team in Ortega.

Ortega lies inland, over six miles from the coast. About 7 miles, as the crow flies, separate Ortega from Jacksonville.

What's Included

A rebuild from take-down to cap

Each course tested by hand to set the take-down line
Roof protected where brick and mortar could land
Brick lowered by bucket or chute, never thrown
Work days and cure time for the Ortega job in writing

Call (904) 920-5495 Free Inspection

How It Works

How our rebuild specialists work in Ortega

Take-down line marked
We test each row of brick from the top down and mark where sound brick starts.
Old brick taken down by hand
The flue is covered and the roof protected, then brick comes off a row at a time, with sound brick saved to relay.
Relaid plumb around the flue
Brick goes back in matched mortar with tooled joints, around new clay tile or ready for a listed liner, and is flashed into the roof.
Crown cast, cap on last
A new crown with an overhang and a drip edge cures before the cap goes on and the first fire is lit.

Local Conditions

Matching the old brick in Ortega

The closest match for a rebuilt chimney is its own brick. Sound units from the take-down are cleaned and relaid, and new brick is chosen for size first so the courses line up.

New mortar looks darker at first and settles as it cures, and the estimate tells you where each brick will come from.

10% off your first service when you book today

Loose or leaning chimney? Call today and your first service is 10% off.

Call (904) 920-5495 Free Inspection

Where new flue tile starts and how far it may lean

The code sets where clay tile begins. For a flue serving an appliance, it starts no less than 8 inches under the lowest inlet; for a fireplace, it starts at the top of the smoke chamber, and it runs to a point above the enclosing walls (FBC R1003.12).

The tile runs vertically where it can, and where it must offset, the slope stays within 30 degrees of vertical. A rebuild that goes low enough to reach the smoke chamber rebuilds that starting point too, and you know in advance how far down the new tile begins. The first tile sits on a solid base, clear of loose rubble.

Protecting fresh mortar and concrete

New mortar and a cast crown gain strength slowly, and two things harm them early: rain that washes the surface before it sets, and drying so fast that the mix cannot cure. Both show later as crumbly joints or a crazed crown.

Fresh work is covered at the end of each day and whenever rain threatens, and the crown is kept damp as its data sheet directs. The schedule leaves room for those cure periods, which is why a rebuild does not finish on the day the last course is laid. Hot, windy days call for shade and damp burlap just as rainy ones call for covers.

Water repellent on rebuilt masonry

Fresh masonry can take a water repellent once it has cured, and the product's data sheet says how long to wait. A breathable, penetrating repellent lets moisture inside the brick escape as vapor while slowing rain from soaking in, which film-forming coatings do not.

Repellent is not a substitute for a good crown, tight flashing and tooled joints; it works on top of them. Whether it is worth applying depends on the brick and the exposure, so it is offered as an option, with the reasoning. It goes on clean, dry masonry, and the data sheet gives the reapplication interval.

Free Inspection

Tested before a rebuild is priced in Ortega

Sound original brick cleaned and set aside to relay
Joint profile tooled concave or V once the mortar firms
Counterflashing let into new joints over the roof's step flashing
Height checked against the roof and anything within 10 feet

FAQ

Before the first brick comes off

Will the rebuilt section look like the rest of the chimney?

Original brick is reused where it tests sound, and new brick is chosen for size, then color and texture. New mortar shades differently at first and settles as it cures. An exact match is not something anyone can promise; the estimate shows which brick is planned.

What if you find the footing is the problem?

Then that comes first in writing, because rebuilding the top of a chimney whose base has moved does not stop the lean. It also says who would evaluate the footing.

Our Services