Family-run gas fireplace insert installation in Julington Creek Plantation
Local gas insert pros clean the old chimney, run the liners to the top and set the insert in Julington Creek Plantation. The inspection is free.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Gas insert experts for Julington Creek Plantation homes
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Old wood chimneys are cleaned before any gas appliance connects, as the fuel gas code asks.
- Free inspection and estimateThe opening, flue and mantel of your Julington Creek Plantation fireplace are measured against the insert's plate at no charge.
- Upfront pricing, no hidden feesInsert, vent kit, surround, cleaning and repairs are priced line by line, and the gas and power trades are named.
- 100% satisfaction guaranteedIf the insert does not light, burn or seal the way its manual describes after our installation, we come back.
Choosing the pipe for the flue
The pipes that run up the chimney for a gas insert come in aluminum and stainless steel. Aluminum is lighter and cheaper; stainless lasts longer where the pipe cannot easily be reached again after installation. Stainless also shrugs off moisture better at the top of a chimney.
Access decides the material, since a pipe hidden behind a sealed chimney top should be the longer-lasting one, and the estimate names what was picked. Wondering which suits your Julington Creek Plantation chimney? Ask a gas insert specialist at (904) 920-5495.
The county for Julington Creek Plantation is St. Johns County. Julington Creek Plantation does not reach the coast.
What gas insert installation covers in Julington Creek Plantation
- Chimneys cleaned before any gas appliance connects
- Dampers removed or fixed open for the liners
- A first light with you at your Julington Creek Plantation home
- Yearly service set up from the first day
Measure, clean, reline, light
-
Measure against the plate
Opening, flue and mantel are checked against the insert's rating plate and manual.
-
Clean and check the chimney
The old flue is cleaned, examined and repaired if needed before the liners go up.
-
Liners, insert, surround
The vent kit runs to its termination, the insert is set and the surround fitted.
-
Hookups and first light
The gas and electrical hookups are made, then we light and test the insert with you.
A chimney with two flues in Julington Creek Plantation
A chimney in Julington Creek Plantation with two flues needs sorting out first, since the gas insert gets a flue to itself.
We trace each flue first.
10% off any service booked within 72 hours of inspection
Liner, insert and the light-up checks at your Julington Creek Plantation home are all discounted.
Co-linear venting, two liners side by side
A co-linear system uses two separate flexible liners inside the old flue: one brings outdoor air to the insert, the other carries exhaust away. One maker's kit uses a 3-inch liner for intake and a 4-inch liner for exhaust, both two-ply flexible liner approved for venting gas appliances.
At the bottom, an adapter joins them to the insert's collar; at the top, a co-linear termination kit and its flashing close the chimney. Co-linear kits are common in fireplace conversions because two small flexible liners get past a narrow throat more easily than one large rigid pipe.
Mantel clearance above a gas insert
Heat rising from a gas insert reaches the wall and anything fixed to it. One maker's rating plate lists 12 inches from the top of the appliance, as the plate words it, to the underside of a combustible mantel that projects up to 3 inches, and refers to its installation manual for deeper mantels.
Deeper mantels need more height, following a chart in the manual. We measure your mantel's height and projection against the figures for your model before ordering, and a mantel that falls short means a different model, a raised mantel or a noncombustible one. The choice is made on paper first.
One gas, set at the factory
Natural gas or propane is decided at the factory, and the rating plate says which. The orifices, pressures and sometimes the valve differ between the two, and a unit is converted only with its maker's conversion kit.
We confirm the gas at the house and the gas on the plate before the insert is delivered. Where a conversion is needed, the kit is ordered with the insert and fitted as its instructions say, with the conversion label applied. Running an insert on the wrong gas is not something to adjust around; it is corrected before first light.
Opening, flue and mantel on paper
- Inside flue size and route checked for the liners
- Liner bend radius kept through the throat and smoke shelf
- Damper removed or fixed open, and any trimming noted
- Outlet position behind the surround, wired by an electrician where needed
Gas insert questions from Julington Creek Plantation
Can my fireplace in Julington Creek Plantation take a gas insert?
It depends on the opening size, the flue and the mantel above it, measured against the insert's rating plate. We check all three on a free inspection before you choose a model.
Does a gas insert need yearly service?
Yes. Makers want a yearly check of the insert and its venting by someone qualified, and we can put that on the calendar from the day it goes in.
More services in Julington Creek Plantation
-
-
-
-
-
-
Learn more about gas fireplace insert installationAll services in Julington Creek Plantation
Easy heat from the fireplace in Julington Creek Plantation
A local gas insert specialist checks the chimney in Julington Creek Plantation and writes the full price down.
Free Inspection