Gas fireplace installation in Green Cove Springs by local specialists
A gas fireplace for a room in Green Cove Springs with no chimney, venting through the wall where a free inspection shows the clearances allow.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Local gas fireplace experts for new installs in Green Cove Springs
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
We hand over the manual and show you the controls before we leave.
- Family owned and operatedOne family business frames, vents and starts up the unit in Green Cove Springs, and lines up the gas and electrical trades.
- Workmanship warrantyThe workmanship warranty applies to our venting, framing and start-up, and the unit keeps its maker's terms.
Permit and inspections for a gas installation
Gas fireplaces go in under a permit, pulled before work starts and closed out with a final inspection. In between, an inspector looks at the parts that will be hidden: the gas connection, the vent run with its supports and firestops, and the framing around the unit. For the Green Cove Springs job, those checks are placed in the schedule so no wall is closed early, and the permit is priced as its own line. The inspector checks the work against the unit's manual, so a copy stays with the unit from the first day of work. Natural gas or propane at your Green Cove Springs home? Say which on the call to (904) 920-5495.
Clay County Historic Courthouse can be found in Green Cove Springs. Green Cove Springs sits in Clay County.
Gas fireplace installs around Green Cove Springs
- Direct-vent or B-vent unit chosen for the room
- Vent route drawn and checked against the vent table
- Termination kept clear of windows, soffits and the meter
- Gas line to the shutoff valve assigned to a gas contractor
Vent out, frame, wire, start up
-
Vent exit found first
We find where the vent can leave the house within the manual's clearances, then pick the unit to suit.
-
Frame and run the vent
The enclosure and header are framed to the drawing, and the vent is run with its supports, pitch and firestops.
-
Trades, wiring and gas
Wiring goes in before the wall closes, and the gas contractor brings the line to the shutoff valve.
-
Start-up and inspection
Pressures are read, joints leak checked, the inspector signs off, and we go over the controls with you.
Permits for gas fireplaces in Green Cove Springs
A new gas fireplace needs a permit from the local building department, with inspections of the gas connection, the vent and the framing.
We put those inspections on the schedule for your Green Cove Springs install and close the wall only after they pass.
10% off any service booked within 72 hours of inspection
Settling on a model for a room in Green Cove Springs takes time, and the 72 hours give you some.
Rear vent or top vent, set before framing
Some direct-vent units ship as rear-vent models, with the pipe leaving the back of the firebox straight toward the outside wall, and can be converted to top vent for a route that rises first. The choice depends on where the termination can go. Set against an outside wall, a rear-vent unit gets the shortest possible run.
A top-vent unit set away from the wall, or one that has to climb to a roof exit, needs the vertical rise that the vent table allows. The conversion follows the manual and is done before the unit is set in its framing. The manual lists which configurations the unit allows.
Keeping clear of the gas meter
The gas meter's pressure regulator has a small vent that can release gas, and a fireplace termination nearby could ignite it or draw it in. The clearance table in the manual sets a minimum distance between the termination and the regulator vent outlet, along with separate distances from mechanical air intakes such as those on air handlers and ventilators.
On the site walk we find the meter and any intake on the same wall, measure to each, and keep the termination away from both. If the best remaining spot is too close, the route changes. Both distances go on the plan.
Sizing the supply to the input
Full rated input, at the pressure on the rating plate, is what the burner needs, measured at the valve with the burner running. The supply line from the meter or tank has to deliver that while the water heater, range and any furnace run too. Sizing that line is the gas contractor's job, done to the fuel gas code's tables, and it may mean a larger line or a new branch rather than a tap off the nearest pipe.
At start-up the inlet reading tells whether the supply did its job. A low inlet reading at start-up goes back to the gas contractor instead of into an adjustment at the valve.
Unit, vent route and trades on paper
- Horizontal pitch and support spacing set as the manual shows
- Roof covering around a roof termination, and who patches it
- Gas supply to the shutoff valve, named with the trade that runs it
- Inlet and manifold pressures read and recorded at start-up
Gas fireplace install questions from Green Cove Springs
Can I choose the tile or stone around the fireplace?
Yes, within the manual's rules. Only noncombustible materials may cover the metal face, set with the adhesive rating the manual gives, and a mantel follows the manual's chart.
Does the 10% discount cover a gas fireplace installation?
It does, when you book the installation within 72 hours of the free inspection. The written estimate shows the 10% off as its own line.
More services in Green Cove Springs
-
-
-
-
-
-
Learn more about gas fireplace installationAll services in Green Cove Springs
Add a gas fireplace in Green Cove Springs
A direct-vent unit needs a path out through a wall or the roof, and our gas fireplace experts find it on your home in Green Cove Springs. Call (904) 920-5495.
Free Inspection