Chimney flue tile replacement in Green Cove Springs

Clay liners, mortar and flue size handled the way the code sets them out, on Green Cove Springs chimneys large and small.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Local flue pros for Green Cove Springs chimneys

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Local and family owned, we come back to the same Green Cove Springs chimney if a repair slips.

Free inspection and estimateThe flue at your Green Cove Springs home is swept, examined from both ends and mapped at no charge.
100% satisfaction guaranteedIf the repaired flue is not sound and correctly sized when we finish, we make it right.
Family owned and operatedA family business maps the flue and does the repair, so the plan and the work stay in one set of hands.

Call (904) 920-5495 Free Inspection

Two flues side by side

Two flues in one chimney, one for the fireplace and one for another appliance, should have masonry between them. The code asks for a wythe at least 4 inches thick, tied into the chimney walls. Where that divider is missing or broken, smoke from one flue can leak into the other.

We check the divider along with each tile. A cracked tile next to a missing wythe is a bigger problem than the same crack in a flue that stands on its own, and the estimate treats it that way. Two flues in your Green Cove Springs chimney? Phone (904) 920-5495 for a free flue inspection.

Clay County Historic Courthouse can be found in Green Cove Springs. Green Cove Springs sits in Clay County.

Flue repairs we handle in Green Cove Springs

Gaps at the smoke chamber closed
Relining quoted plainly when repair will not hold
Flue repair for fireplaces and appliance flues alike
Flue mapped at your Green Cove Springs home before any price is given

Call (904) 920-5495 Free Inspection

Sweep, map, repair, check

Swept and examined
The flue is cleaned, then looked over from the roof and the firebox with a light and mirrors.
Mapped and measured
Each defect is placed by height and wall, and the flue size is checked against what it serves.
Repaired by the chosen method
Top tiles swapped from the roof, damaged sections coated with a listed system, or a relining price when repair will not hold.
Checked and cured
The finished flue is examined from both ends and left to cure before the first fire.

Rain through an uncapped flue in Green Cove Springs

Uncapped flues take rain straight down, inland or not. Soaked joints lose their mortar sooner than dry ones.

A cap priced with a flue repair in Green Cove Springs keeps the new work dry.

10% off any service booked within 72 hours of inspection

Flue repair earns the 10% off even if you have booked with us before.

Call (904) 920-5495 Free Inspection

Why the code asks for a lined chimney

Section R1003.11 of the Florida residential code requires a lining in every masonry chimney, of a type that suits whatever appliance is connected, as its listing and maker direct. The liner is a separate duct inside the chimney walls, and its job is to carry smoke, gases and condensate up and out without letting them into the brick.

Repair work restores that duct. Whatever method is used, the result has to be a continuous, sealed passage from the bottom of the lining to the top. A repair that closes one crack but leaves an open joint below it has not done the job, which is why the whole flue is examined before any single fix is priced.

Flues that bend and the 30 degree limit

Leaning is allowed in a flue lining, within a limit. The code allows a slope no greater than 30 degrees from vertical. Beyond that, gases slow, deposits settle and the bend becomes hard to clean.

At an offset, tiles are cut on an angle and the joints are awkward to fill, so cracks and gaps cluster there. Repairs at a bend have limits too. Tools for resurfacing must pass the angle, and a replacement tile must be cut to match it. We note each offset's position and angle on the flue map, since it decides which repair can reach the damage.

Masonry between neighboring flues

When a chimney carries two or more flues, R1003.13 puts a masonry wythe of 4 inches or more between neighboring linings, tied into the chimney walls. The divider keeps one flue's heat and gases out of the next, and it gives each flue its own draft.

Old chimneys sometimes have the divider cracked or missing. It matters more when the flues serve different appliances, since leakage between them can pull fumes into a flue that should be clean. We check each divider we can see and note where it is broken, because it changes whether repairing the tiles alone is enough.

Flue findings written down before pricing

Every defect located by flue, height and wall on a written flue map
Dividers between neighboring flues checked where they can be seen
Inlet thimble and cleanout door condition on appliance flues
Fireplace or appliance use allowed before and after the repair

Flue repair questions from Green Cove Springs

Can one cracked tile be fixed on its own?

If it is the top tile, often yes, from the roof. A single cracked tile lower down usually cannot be reached alone, so it is covered by resurfacing that section or by relining, depending on the rest of the flue.

How do you see inside a flue?

From both ends, with a strong light and mirrors, after the flue is swept. Anything we could not see is written down as not seen, so nothing is guessed.