Gas fireplace installation in Garden City by local specialists

Framing, facing and mantel limits for your Garden City unit come from its manual, checked on a free inspection.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Gas fireplace installation specialists who vent to the manual

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Start-up includes pressure readings and a leak check, written on your Garden City record.

Family owned and operatedOne family business frames, vents and starts up the unit in Garden City, and lines up the gas and electrical trades.
Workmanship warrantyThe workmanship warranty applies to our venting, framing and start-up, and the unit keeps its maker's terms.

Call (904) 920-5495 Free Inspection

Start-up and handover

Lighting the burner is not the end of an installation; the readings are. At start-up the gas pressure is measured coming into the valve and going to the burner and compared with the rating plate, each connection gets a leak-detection solution, and the pilot and main flame are compared with the manual's drawings once the unit is warm. Logs and embers go onto the diagram and the barrier screen goes on.

Before we leave the Garden City house, you run the unit yourself, find the shutoff valve with us, and keep the manual. A year later, the first service is due. Ring (904) 920-5495 with the room you have in mind, and our gas fireplace pros will plan the Garden City install on a free visit.

Garden City falls within Duval County. Garden City lies inland.

What a gas fireplace installation covers in Garden City

Vent exit found on the outside wall or roof first
Vent route drawn and checked against the vent table
Siding standoff fitted behind a wall termination
Permit and inspections for your Garden City install scheduled

Call (904) 920-5495 Free Inspection

How our gas fireplace pros install a unit in Garden City

Vent exit found first
We find where the vent can leave the house within the manual's clearances, then pick the unit to suit.
Frame and run the vent
The enclosure and header are framed to the drawing, and the vent is run with its supports, pitch and firestops.
Trades, wiring and gas
Wiring goes in before the wall closes, and the gas contractor brings the line to the shutoff valve.
Start-up and inspection
Pressures are read, joints leak checked, the inspector signs off, and we go over the controls with you.

Direct-vent in a room with no chimney in Garden City

A direct-vent unit brings its own coaxial vent, so it needs no chimney. It can exit straight through a wall or up through the roof.

That makes a gas fireplace possible in many Garden City rooms that never had one.

10% off any service booked within 72 hours of inspection

Direct-vent or natural-vent, the installation is discounted either way.

Call (904) 920-5495 Free Inspection

Supports, thimbles and firestops

A vent run needs support along its length, at the spacing the manual sets, so joints do not pull apart over time. Where it passes an outside wall, a wall thimble or firestop from the vent maker holds the pipe centered and keeps its clearance to the framing. Where it passes a ceiling or floor, a firestop spacer does the same job.

Horizontal pipe keeps the clearance the manual lists, which on some systems is larger above the pipe than beside it. Air spaces around the pipe stay open, with no insulation packed in. Joints are locked as the vent maker's instructions show.

Restrictor settings on tall runs

A direct-vent run with a lot of vertical rise draws harder than a short one, and too much draft pulls the flame around and can lift it. Manuals handle this with a restrictor, a plate or adjustable damper in the exhaust path, set according to the vent configuration. The table in the manual gives the setting for each combination of rise and run.

We set it during installation and confirm it at start-up by watching the flame after the unit has warmed, adjusting only within the settings the manual lists. A flame that dances or lifts after warm-up is the sign it needs another look.

The first long burn

A new gas fireplace gives off an odor the first time it runs, as the paint and materials cure, so plan on open windows during that burn-off, as the manuals advise. One maker recommends running the unit for an extended period the first time, with the fan switched off. We start that process at handover, open the windows, and tell you what to expect over the first few fires.

An odor that persists after the burn-off, or any smell of gas, is a different matter and a reason to call. Children and pets are best kept out of the room while it happens.

Checked outside and in before an install in Garden City

Unit named by maker and model, with its heater or decorative listing
Horizontal pitch and support spacing set as the manual shows
Roof covering around a roof termination, and who patches it
Permit and inspections placed in the schedule

Before the vent hole is cut

Can a gas fireplace be installed in a house in Garden City without a chimney?

Yes. A direct-vent unit uses its own listed vent pipe through a wall or the roof, so no chimney is needed. The site visit checks where the termination can go.

Does a gas fireplace need an electrical outlet?

Units with electronic ignition or a blower do, in the location the manual shows, and an electrician adds it if one is not there. A standing-pilot unit without a blower can run with no house power.