
Local chimney cap replacement in Fruit Cove
A screen that meets the Florida code and a hood that clears the tile, fitted to your Fruit Cove chimney following a free visit.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Chimney cap specialists who measure in Fruit Cove first
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Factory-built chimneys get the cap their maker lists, which keeps the fireplace in its tested setup.
- Free inspection and estimateWe measure every flue on your Fruit Cove chimney at no charge before any cap is ordered.
- Upfront pricing, no hidden feesThe cap model, its metal and the fastening are priced together, so the total is clear.
- Workmanship warrantyOur fitting and fastening carry the workmanship warranty, with the cap maker's terms in writing.
Capping a flue after birds or animals
Scratching above the damper, chirping in the chimney, or twigs dropping into the firebox mean something has found the flue. A cap is how that stops happening again, but the cap goes on last. Swifts that nest in chimneys are federally protected, so an active swift nest stays until the birds have moved on for the season. Other animals come out first, the nest material and droppings are cleared from the shelf, and only then does the new screen close the opening. That order holds for every Fruit Cove home, so nobody ends up capping an animal inside the flue. Pick a time for our cap pros to come to Fruit Cove; the number is (904) 920-5495.
Fruit Cove had 32,143 residents at the 2020 Census. The coastline lies beyond Fruit Cove.
What a new chimney cap includes in Fruit Cove
- Every flue tile measured inside and out
- Tile height above the crown checked for a secure fit
- Cap on your Fruit Cove home fastened to hold in a storm
- Two-flue chimneys fitted with two caps or one cover
How chimney cap replacement runs
-
Tiles measured on the roof
Each flue tile is measured inside and out, along with its height above the crown.
-
Cap style and metal chosen
Slip-in, band-mount or full-crown, in a metal suited to the roof, with a screen that meets the Florida code.
-
Flue cleared, cap fastened
Any nest or debris comes out of the flue, then the cap is set and fastened for wind.
-
Fit and screen checked
We check that the cap sits square, the hood height matches the chart and the screen comes off for the sweep.
A damper that doubles as a cap in Fruit Cove
A top-sealing damper sits on the flue tile with a hinged, gasketed lid, opened and closed by a cable from the firebox. Closed, it keeps rain, animals and room air where they belong.
When a chimney in Fruit Cove also needs a better damper, we price this option beside a standard cap.
10% off any service booked within 72 hours of inspection
Cap missing or rusted? Book it no more than 72 hours after the inspection and save 10%.
Slip-in caps and the inside of the tile
A slip-in cap has a lower section that drops inside the flue tile and holds with screws or spring clips against the tile wall. It suits a tile with a clean, square top edge and inside dimensions that match a standard size. The fit is measured right at the top of the tile, where old mortar, chips or a rough cut can make the opening smaller than the tile's nominal size.
A slip-in section forced into a tight tile can crack it, and one that sits loose will rattle and walk. When the inside of the tile does not measure true in both directions, a band-mount or outside-mount cap is the better choice, and we explain which and why.
A damper that doubles as the rain cap
Fitted to the flue tile in place of a cap, a top-sealing damper has a hinged lid with a gasket and is opened and closed by a stainless cable that runs down to a bracket inside the firebox. Closed, it seals the flue at the top, which keeps conditioned air in the house and rain out of the flue. Models with a screen in the frame also keep animals out, as a cap would. It is chosen when the throat damper is rusted or warped, and it follows its maker's sizing just as a cap does. The one thing to remember is to open it fully before any fire is lit.
Two caps or one cover for side-by-side flues
Two tiles standing next to each other can each take a single-flue cap, provided there is room for both hoods and both tiles stand clear of the crown. One outside-mount cover over both is the alternative. Separate caps keep each flue independent, so servicing one does not disturb the other, and they need less metal. One cover shields more of the crown and puts no fasteners into the tiles, but it needs sound concrete to anchor into. We measure the spacing between tiles and their heights before recommending either, and when both would work, you see the two priced side by side.
Tile sizes we take in Fruit Cove before ordering
- Crown condition under a full-crown cap, written as its own line
- Hood height above the tallest tile, per the maker's drawing
- Fastener metal matched to the cap to avoid galvanic corrosion
- Clean-up of old metal, screws and debris from the roof and yard
Before a new cap is ordered
Do you replace chimney caps in Fruit Cove?
We do. Call or send the form, tell us what you see at the top of the chimney, and we set a time to measure in Fruit Cove.
What does the screen on a cap have to meet?
Section R1003.9.2 of the Florida residential code sets the open area, the screen's heat and corrosion resistance, the opening size and removability for a spark arrestor on a masonry chimney. We check the cap we propose against each point.
More services in Fruit Cove
-
Hurricane and Storm Damage Chimney Repair Wind and water damage to caps, covers, crowns, flashing and masonry repaired.
-
Chimney Rebuild Loose, cracked or leaning masonry taken down to sound brick and relaid.
-
Top-Sealing Damper Installation A gasketed damper fitted at the flue top to replace a failed throat damper.
-
Firebox Repair Cracked firebrick and open refractory joints in a masonry firebox.
-
Prefab and Zero-Clearance Fireplace Repair Refractory panels, firebox metal and chimney pipe on factory-built units.
-
Chimney Animal Removal Animals and nests cleared from the flue, debris cleaned out, entry closed off.
Learn more about chimney cap installation and replacementAll services in Fruit Cove
Get your Fruit Cove chimney capped properly
Cap leaning or gone after a storm in Fruit Cove? We measure the flue and name the cap that fits, in writing.
Free Inspection