Wood-burning fireplace inserts installed in Fernandina Beach
Your Fernandina Beach insert installation priced in writing, part by part, with repairs listed first and no hidden fees.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Wood insert experts for Fernandina Beach homes
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
The liner runs full length and matches the insert collar, the setup insert makers call the safest.
- Free inspection and estimateYour Fernandina Beach firebox, chimney height and hearth are measured against the insert's manual at no charge, before anything is ordered.
- Upfront pricing, no hidden feesEvery part of the job is priced before ordering, from repairs to the rain cap, and nothing is added without your yes.
- 100% satisfaction guaranteedIf the insert smokes or draws poorly after installation to its manual, we come back and set it right.
Planning the install date
Insert installations run in a set order: the inspection, any fireplace repairs and their drying time, the insert and liner arriving, then the install day. Repairs in refractory mortar need days to dry before heat, and that sets the earliest date for the first fire.
We lay the order out on the estimate so you can see when each step happens and who comes for it. Hoping to have an insert running by a certain date in Fernandina Beach? Tell us the date when you book at (904) 920-5495, and we will say whether it is realistic.
At the 2020 Census, Fernandina Beach was home to 13,052 people. Fernandina Beach sits on the coastline.
Insert installation for Fernandina Beach fireplaces
- Top plates and rain caps closing the old flue
- Mantel and trim clearances measured to the label
- Inserts in factory-built fireplaces only where both allow it
- Model, liner and clearances recorded for your Fernandina Beach house
From tape measure to first fire in Fernandina Beach
-
Measure against the manual
Firebox, chimney height, hearth and clearances are checked against the insert's table before ordering.
-
Repair and clean first
Fireplace repairs are made and cured, and the flue is cleaned before the liner goes up.
-
Liner, plate and cap
A listed stainless liner runs to the top, closed with a top plate and a rain cap.
-
Set, seal and fire
The insert and surround go in as the manual directs, and the first fire is run with you.
A coastal chimney and a new liner in Fernandina Beach
Before a liner goes into a chimney on the coast in Fernandina Beach, the top of the flue gets a close look, since the top plate will rest on it.
Rust or cracking at the flue top goes on the estimate, and the plate is fitted once the top is sound.
10% off any service booked within 72 hours of inspection
Insert measured through us in Fernandina Beach? Book it inside three days and 10% comes off.
Stainless liners and the UL 1777 listing
Chimney liners are tested and listed under UL 1777, and an insert liner should carry that listing for its use. For an insert in a factory-built fireplace, one maker requires the full-length stainless liner to meet the Type HT rating, tested to 2,100 degrees Fahrenheit, and to be fixed at both the collar and the chimney top.
We order liners by listing, diameter and length, and the liner's own instructions set its bend limits, its insulation where required and its fittings. The liner make and listing go on the ticket beside the insert's model, so anyone servicing it later knows what is in the flue.
No grate inside the insert
Open fireplaces burn on a grate, but an insert usually does not. One maker's manual says not to raise the fuel on grates or andirons and to burn directly on the firebricks inside the insert, replacing any broken or missing bricks before use.
Those firebricks line the insert's own firebox and are a maintenance item of their own. We check them at installation and show you what a cracked one looks like, so a broken brick is replaced from the maker's parts list instead of being ignored. The old fireplace grate comes out before the insert goes in.
Driftwood and salt near the coast
Wood that has sat in salt water is a poor fuel for an insert. One maker lists salt water wood among the materials not to burn, because the chlorides it carries rapidly destroy metal surfaces and void the warranty.
Near the coast, driftwood can look like free fuel for the season. We point this out at the walk-through, along with treated wood, garbage and the other items the same maker bans, so the steel firebox, the baffle and the liner are not eaten from the inside. A stack of driftwood by the hearth is worth moving outside for good.
Fireplace, flue and hearth on paper first
- Full-length stainless liner, listed to UL 1777, matched to the collar
- Mantel, side facing and side wall clearances measured to the label
- Metal tag fixed to the fireplace back wall when the manual supplies one
- First fire run with you, covering the air control and loading
Wood insert questions from Fernandina Beach
Can any fireplace in Fernandina Beach take a wood insert?
No. The fireplace must be at least the size the insert's manual lists, sound or repaired first, with a chimney tall enough and a flue of its own. We check all of it on a free inspection.
What happens to the damper?
It stays fixed open or comes out entirely, so the liner has a clear path. Some manuals allow trimming parts of the damper frame or smoke shelf, only where the fireplace is not weakened.
More services in Fernandina Beach
-
-
-
-
-
-
Learn more about wood-burning fireplace insert installationAll services in Fernandina Beach
A wood insert that fits your Fernandina Beach fireplace
Our family-owned installers measure your Fernandina Beach fireplace for an insert at no charge.
Free Inspection