ODS pilot and log service for vent-free fireplaces in Bryceville

Vent-free unit shutting off in Bryceville? We trace why, free of charge, then clean or replace the sensor pilot.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Ventless fireplace specialists for Bryceville homes

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

You are shown how to light and run the unit by hand.

Free inspection and estimateThe rating plate, the room and the flame of your unit in Bryceville are checked on a free visit.
Upfront pricing, no hidden feesCleaning, listed parts and labor are priced in writing before anything is ordered or fitted.
100% satisfaction guaranteedIf the unit does not run the way we said after our service, we come back and put it right.

Call (904) 920-5495 Free Inspection

A gas smell near the unit

Smell gas near a vent-free unit? Leave the house first, and make the call to 911 or the gas utility from outside. Strike no match and leave every light switch as it is while you go.

Once the utility has declared the Bryceville house safe, the unit and its connections can be checked, and any repair on the appliance side is ours. Every joint we open is tested with a leak solution or an instrument, never a flame.

Bryceville is part of Nassau County. Bryceville lies inland.

Vent-free fireplace service we handle in Bryceville

Oxygen depletion sensor pilots cleaned
Gas pressure measured against the rating plate
Igniters, remotes and receivers repaired
Mantel clearances measured against the manual

Call (904) 920-5495 Free Inspection

How our crew services a vent-free unit in Bryceville

Rating plate and gas confirmed
The model, gas, listing and input are read and the gas confirmed at the valve before parts are ordered.
Room measured against the code
The room volume and every unvented input in it are compared with the code and the manual.
Pilot, burner and logs serviced
The sensor pilot and burner are cleaned, the logs set to the diagram and worn parts replaced.
Leak checked and run through a cycle
Opened joints are leak checked, the flame is watched through a full cycle and findings are written down.

Candles and residue indoors in Bryceville

Soot on the walls near a vent-free unit in Bryceville can come partly from candles or other products used in the room, which makers warn about. The coast has no part in that.

When soot appears, the room is checked as well as the flame.

10% off any service booked within 72 hours of inspection

Unit shutting off? Its service is 10% off when you book it inside three days of our look.

Call (904) 920-5495 Free Inspection

Vent-free sets and factory-built fireplaces

Section 621.7 of the fuel gas code and R1004.4 of the residential code bar unvented log heaters from factory-built fireplaces that lack a listing for them. The fireplace's label says whether it has one.

We read that label before servicing a set in a metal firebox. Where the combination is not listed, we write down what we found and explain the options rather than putting the set back into use. Moving the set to a masonry fireplace where it is allowed, or replacing the fireplace, are the alternatives we set out.

Damper open or closed

In a masonry fireplace, the damper may stay closed under a vent-free set only where the manual allows it, for example when the surroundings are noncombustible and the mantel clearances are met. Where those conditions are not met, the manual has the damper open and the set runs vented.

The fireplace is checked against those conditions, and the damper is fixed in the position the manual requires. The reason is written on the ticket, so nobody changes it later without knowing why. A damper clamp or stop keeps the damper where the manual requires, so it cannot be moved by accident.

The first hours on new logs or a new unit

New logs and a new unit can give off an odor for the first hours of use as binders and coatings burn off. One maker's manual calls for an initial run with windows open to clear it.

When we install new logs or parts, we explain the smell to expect and how long that first run should last. An odor that lasts beyond that is a reason to call us back, and the ticket gives the date for reference. Pets and anyone sensitive to odors are best kept out of the room during that first run.

What we check on a vent-free unit in Bryceville

Adjoining space counted only where the manual allows it
Igniter, remote, receiver and thermostat tested and repaired
Damper position confirmed against the manual's conditions
Soot sources traced before any wall cleaning is priced

Before the unit is lit again

Could you set the sensor so it stops tripping?

No. The code forbids field adjustment of the oxygen depletion shutoff, and we never bypass it. A dirty pilot is cleaned, and a worn one is replaced with the listed assembly.

Is my room big enough for the unit?

The room is measured, every unvented appliance in it is added up, and we compare the total with the code's limit of 20 Btu per hour per cubic foot. The arithmetic is written on your ticket.