Local gas fireplace installation for Bellair-Meadowbrook Terrace homes

A gas fireplace for a room in Bellair-Meadowbrook Terrace with no chimney, venting through the wall where a free inspection shows the clearances allow.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Gas fireplace installation specialists who vent to the manual

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

The vent route is checked against the vent table before any framing starts.

Family owned and operatedOne family business frames, vents and starts up the unit in Bellair-Meadowbrook Terrace, and lines up the gas and electrical trades.
Workmanship warrantyThe workmanship warranty applies to our venting, framing and start-up, and the unit keeps its maker's terms.

Call (904) 920-5495 Free Inspection

Replacing an old gas fireplace

When a gas fireplace has worn out or its parts are no longer made, the replacement starts with the vent. A new unit can reuse the existing vent only when its manual lists that vent system, sizes and parts included, and that is not something to assume. On a replacement in Bellair-Meadowbrook Terrace, we identify the old vent by maker and diameter, check it against the new unit's manual, and write down whether it stays or is replaced. The framed opening is measured too, since a new unit's framing dimensions come from its own manual rather than the old one's. Ring (904) 920-5495 with the room you have in mind, and our gas fireplace pros will plan the Bellair-Meadowbrook Terrace install on a free visit.

Bellair-Meadowbrook Terrace lies inland. Bellair-Meadowbrook Terrace is part of Clay County.

What a gas fireplace installation covers in Bellair-Meadowbrook Terrace

Heater or decorative listing matched to your plan
Horizontal runs pitched the way the manual asks
Facing and mantel planned from the manual's chart
Permit and inspections for your Bellair-Meadowbrook Terrace install scheduled

Call (904) 920-5495 Free Inspection

How gas fireplace installation runs

Vent exit found first
We find where the vent can leave the house within the manual's clearances, then pick the unit to suit.
Frame and run the vent
The enclosure and header are framed to the drawing, and the vent is run with its supports, pitch and firestops.
Trades, wiring and gas
Wiring goes in before the wall closes, and the gas contractor brings the line to the shutoff valve.
Start-up and inspection
Pressures are read, joints leak checked, the inspector signs off, and we go over the controls with you.

Wiring before the wall closes in Bellair-Meadowbrook Terrace

Remote receivers, wall switches and blowers need wiring run before the finish goes on. Running it later means cutting into the new wall.

On installs in Bellair-Meadowbrook Terrace, the electrician's rough-in is on the schedule before the drywall.

10% off any service booked within 72 hours of inspection

Direct-vent or natural-vent, the installation is discounted either way.

Call (904) 920-5495 Free Inspection

What the unit sits on

The manuals we install from let a unit sit directly on wood flooring or a subfloor. When it would sit on carpet, tile or another combustible surface other than wood flooring, the manuals call for a metal or wood panel under the full width and depth of the unit. The unit is then secured to the floor or to the framing with the fasteners and points the manual shows, so it cannot shift when the facing is installed or the glass is removed for service. Raised platforms are built to the same rule, with the panel on top. The panel goes on before the unit is slid into place.

Propane tanks and the fireplace

A propane fireplace runs off a tank outside the house, and the manuals are explicit that propane tanks do not go inside any structure. Some manuals set a minimum tank size so the tank can vaporize enough gas to keep up with the unit, which matters on small tanks.

The regulator at the tank and the line to the house belong to the propane supplier. We confirm with the supplier that the tank, regulator and line suit the fireplace's input before the unit is ordered, so start-up is not the first time anyone checks. The supplier's answer is kept with the installation plan.

The volume rule for B-vent units

A B-vent fireplace takes its combustion air from the room, so the fuel gas code limits where it can go. In a bedroom, it is allowed only when the room has at least 50 cubic feet of volume for each 1,000 Btu per hour the unit burns, the code's standard method.

A small bedroom can fail that test with a modest unit. A direct-vent unit, which takes all its air from outside, is not held to the same volume rule when installed to its listing. We do the arithmetic from the room's measurements before recommending either. Ceiling height counts, so a tall room holds more volume than its floor area suggests.

Checked outside and in before an install in Bellair-Meadowbrook Terrace

Horizontal pitch and support spacing set as the manual shows
Termination spot measured to windows, soffits, corners and walks
Service access panels left removable after the finish
Barrier screen fitted and logs set to the placement diagram

Before the vent hole is cut

Do you run the gas line to the new fireplace?

No. The line to the unit's shutoff valve is a gas contractor's job, or the propane supplier's on a propane system. The estimate says who and when, and start-up follows once gas reaches the valve.

Can I choose the tile or stone around the fireplace?

Yes, within the manual's rules. Only noncombustible materials may cover the metal face, set with the adhesive rating the manual gives, and a mantel follows the manual's chart.