Local fireplace insert installation in Avondale
A wood stove insert in Avondale connected to a stainless liner sized to its collar, with the damper locked open or removed.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Local insert pros who install to the listing
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Clearances to your mantel and trim in Avondale are measured to the label before you order.
- Free inspection and estimateYour Avondale firebox, chimney height and hearth are measured against the insert's manual at no charge, before anything is ordered.
- Upfront pricing, no hidden feesEvery part of the job is priced before ordering, from repairs to the rain cap, and nothing is added without your yes.
- 100% satisfaction guaranteedIf the insert smokes or draws poorly after installation to its manual, we come back and set it right.
A tag on the back wall
Changing a fireplace to take an insert, by cutting the damper for example, leaves it different from how it was built. Some makers supply a small metal tag for the back wall so that anyone who pulls the insert out later knows the fireplace was altered and is not ready for open fires as it stands.
We fit any tag the manual calls for and record the alterations on the ticket. It is a small part that saves confusion years later. Want a fireplace insert installed properly in Avondale, down to the paperwork? Ask for a free visit at (904) 920-5495.
Avondale sits in Duval County. Avondale is inland.
What fireplace insert installation covers in Avondale
- Firebox measured against the insert's size table
- Fireplace repairs finished before the insert goes in
- Older unlined inserts reconnected to a liner
- Blower outlets planned with an electrician
From tape measure to first fire in Avondale
-
Measure against the manual
Firebox, chimney height, hearth and clearances are checked against the insert's table before ordering.
-
Repair and clean first
Fireplace repairs are made and cured, and the flue is cleaned before the liner goes up.
-
Liner, plate and cap
A listed stainless liner runs to the top, closed with a top plate and a rain cap.
-
Set, seal and fire
The insert and surround go in as the manual directs, and the first fire is run with you.
Blower power for an inland insert
Blowers need a grounded outlet near the fireplace. In Avondale, as anywhere, adding one is work for an electrician.
We plan the outlet location with you before the install day.
10% off any service booked within 72 hours of inspection
The insert, the liner and the labor are all discounted.
Sizing the liner to the collar
The insert collar sets the liner size. One maker's insert uses a 6-inch stainless liner, and its manual shows the liner attached to a stove connector at the insert and running full length above it.
A liner smaller than the collar chokes the insert, and one larger than needed gives slow, cool smoke the same way the old flue did. We confirm the collar size on the unit itself, check that the flue has room for the liner and any insulation the listing calls for, and order to that size. Where the flue is too tight, the estimate says so before the order.
Door gasket and glass on a wood insert
The door gasket seals the loading door, and one maker's gasket needs only light pressure to seal, which extends its life. The gasket is checked periodically and replaced with the maker's kit when it no longer seals.
The glass is ceramic, and the same maker specifies 5 mm ceramic glass of a set size with no substitutes. It should not be slammed or struck by a log sticking out of the load, and it is cleaned only when cold with a non-abrasive cleaner. We show you both parts on install day and where the replacements come from.
The baffle above the fire
Inside the top of a wood insert sits a baffle, a plate with insulation that holds the flames and gases in the firebox longer. One maker says not to operate the insert with the baffle or its insulation removed.
The same maker prefers removing the insert and pipe to clean and inspect, taking out the baffle only when that is not possible. We set the insert up so the baffle and connection can be reached, and show you the baffle's position so it is not left out after cleaning. A missing baffle shows as a fire that roars up the flue.
Fireplace, flue and hearth on paper first
- The four firebox dimensions set beside the insert maker's size table
- Damper locked open or removed, and what the manual lets us trim
- Surround sealed or left open as the manual directs for the air source
- Metal tag fixed to the fireplace back wall when the manual supplies one
Wood insert questions from Avondale
Do I need a full liner for an insert?
Insert manuals allow a full liner or, where they permit it, a short positive connection. The full liner drafts better and is easier to clean, and it is what we recommend and price first.
Is the inspection before an insert free?
Yes. Measuring the firebox, checking the chimney and writing the estimate cost nothing, and the price is set out upfront. Order the insert within 72 hours of that visit and the job is 10% off.
More services in Avondale
-
-
-
-
-
-
Learn more about wood-burning fireplace insert installationAll services in Avondale
Book an insert check in Avondale
Cold room, open fireplace in Avondale? A free visit tells you whether an insert will fit.
Free Inspection