Electric fireplace repair for American Beach homes

Electric fireplace repair in American Beach with the unit handled carefully, the wall protected and every function retested.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Repair specialists who test before they order

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Inserts and wall units are handled with the trim and wall protected.

Free inspection and estimateYour American Beach unit is tested part by part, from the outlet to the board, at no charge.
100% satisfaction guaranteedIf the repaired unit does not heat, light and respond as its manual says, we return and put it right.
Family owned and operatedThe family crew that traces the fault in your unit is the crew that repairs it.

Call (904) 920-5495 Free Inspection

Flames frozen in place

A flame effect that stops moving, or stutters and jumps, usually has a mechanical cause. In many units, a rod with reflective strips turns in front of the lights, driven by a small motor. If the rod slips off the motor shaft, or the motor fails, the flames freeze. A stutter that comes and goes can also be a rod rubbing at its far end.

Dimplex notes the rod can come loose from its motor, and that is often a quick fix. A dead motor is replaced with the maker's part. Flames stuck or twitching on your electric fireplace in American Beach? Call (904) 920-5495, and our repair pros will check the motor and rod at no charge.

American Beach falls within Nassau County. American Beach lies on the coastline.

Electric fireplace repairs we handle in American Beach

Flicker rods reseated and motors replaced
Remotes and receivers paired or replaced
Inserts pulled out, repaired and refitted
Airways cleaned of dust and pet hair

Call (904) 920-5495 Free Inspection

How electric fireplace repair runs

Model number first
Read us the rating label, and parts availability is checked before the visit.
Supply, then each part
The outlet and breaker are checked, then heater, fan, flame effect, board and remote are tested in order.
Failed part replaced
The maker's part for your serial number is fitted, with any electrician work done separately.
Retested with you
Heat, flames, remote and thermostat are run through their settings before we leave.

Damp and electronics in a coastal home

Makers warn against damp locations. By the ocean, a unit placed beside a door that opens to wind and rain gets wetter air than one on an inside wall.

When a repair in American Beach turns up corrosion inside, we say whether the location may be the cause.

10% off any service booked within 72 hours of inspection

Electric unit acting up? The part and the labor are both discounted.

Call (904) 920-5495 Free Inspection

Checking the supply before the unit

Every repair visit starts outside the fireplace. We check the outlet for power, the breaker for a trip, the cord for damage and the plug for heat marks. Many units also have a main power switch hidden on the side or behind a panel, and it is easy to switch off by accident.

Only when power is confirmed at the unit do we open it. That order saves money, because a surprising number of dead fireplaces come back to life at the breaker or the hidden switch. If the outlet or wiring is at fault, it goes to an electrician under NFPA 70. A switched outlet controlled by a wall switch catches out more owners than any failed part.

Pulling an insert out of the firebox

An electric insert sits in an old firebox, usually with a trim surround. To repair it properly, the trim comes off and the insert slides forward onto the hearth, with its cord followed so it is not strained.

The unit is opened and tested there, repaired and closed up. Before it goes back in, we check the cord for wear and the firebox for anything that may have fallen behind the insert. Once it is back, it is tested in place, and the trim is refitted so it sits tight against the fireplace face. The hearth is covered while the insert sits on it, so neither is scratched.

Comparing repair with replacement

Repairing stays the sensible choice until the part list or the total says otherwise. One failed part that is still made is usually worth replacing. When several parts have failed, or the board and heater have both gone, the repair total can approach the price of a new unit.

We put both side by side in writing. The repair lists each part and its labor. The replacement notes what a new unit would involve, including whether the existing bracket, opening or firebox fits a current model. The decision is yours, with both totals on one page. Where a replacement is chosen, the old unit's bracket or opening is checked for reuse.

What we test on units in American Beach

Rating label copied: model, serial, volts and watts
Connectors inside the unit checked for fit and heat marks
Intake and fan cleaned of dust and pet hair
Old parts taken away and the area cleaned

Before a part is ordered

Why does my unit heat for a while and then stop?

Often the thermal cutoff is doing its job because the unit is running too hot inside, from a blocked intake, packed dust or crowded trim. We reset it, find the cause and fix that.

The flames stopped moving. Is that expensive?

Often not. A flicker rod that has slipped off its motor shaft is a quick fix. A failed motor is replaced with the maker's part, which is still a modest repair.