Family-owned stone chimney repair in San Marco
A local family business for stone chimneys in San Marco, with 10% off stone work you book inside three days of the inspection.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Stone chimney specialists for San Marco homes
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Joints are raked to sound mortar and filled in layers, never skimmed over.
- Free inspection and estimateWhether your San Marco chimney is full stone or veneer is settled on a free visit, before any price.
- Upfront pricing, no hidden feesStones, joints and veneer area are priced in writing one line at a time.
- Family owned and operatedOur family-owned masons approve the mortar sample with you before the first joint is filled.
Veneer pieces on the roof or the lawn
Flat stone pieces found below a chimney, with mortar still stuck to their backs, are veneer that has let go of its base. Adhered veneer carries no weight of its own; it holds on by bond alone, so once one piece drops, the pieces beside it deserve a close look. Veneer pieces are heavy enough to damage a roof or hurt someone when they fall from height.
Keep people clear below the chimney. Then call (904) 920-5495, and our specialists in San Marco will check the pieces around the gap and what is behind them, and tell you in writing how far the loose area runs.
San Marco is inland. San Marco is a neighborhood inside Jacksonville city limits.
From one loose stone to a veneer reinstall
- Deep stone joints raked and repointed in layers
- Cracked stones replaced with matched pieces
- Base drainage exits opened and restored
- Veneer cut back from the roof surface
From the first loose stone to the last tooled joint in San Marco
-
Describe what moved
Tell us what has shifted or fallen, and the free visit comes equipped for it.
-
Build and backing confirmed
Corners, joints and the base show the build, and a loose piece shows what is behind the veneer.
-
Reset, repoint or reinstall
Stones go back on fresh beds, joints fill in layers, and veneer returns to a repaired backing.
-
Matched and cured
An approved mortar sample and the old joint profile guide the finish, and the cure time is written down.
Rain and open joints in San Marco
Away from the coast, a stone chimney in San Marco still takes every rain on its joints. Mortar erodes, water reaches the core, and stones loosen one by one.
Repointing in layers with a matched mortar is the repair, and we price it by the run of joints.
10% off any service booked within 72 hours of inspection
On a stone chimney in San Marco, the mortar match and the discount both go in writing.
Resetting a loose stone
A loose stone comes out, and both the stone and its bed are cleaned down to sound mortar. The stone goes back on a fresh bed, adjusted to line up with its neighbors, and the joints around it are packed and tooled once the bed has firmed.
If the bed behind the stone has turned to sand deep into the wall, resetting one stone will not hold, and the repair widens to the area around it. We tell you that before starting, with the extra stones counted, rather than after the first stone is out. Small stone spalls or wedges are used to hold the stone in line while its bed sets, then removed or hidden in the joint.
Why adhered veneer lets go
Adhered veneer holds on by bond alone. That bond fails when water sits behind the stone, when the lath corrodes, when the backs of the stones were dusty or dry when set, or when the setting mortar was not spread over the whole back of each piece.
The pieces themselves tell the story: a clean back means the bond never formed, mortar stuck to the back means the scratch coat or lath let go, and rust stains point to the metal. We read those clues before choosing between resetting pieces and rebuilding the backing. That diagnosis decides whether the rest of the veneer is at risk or whether the failure is local.
Testing where water gets behind the stone
When water shows up inside and the stone looks sound, a staged water test finds the entry. Water goes onto a single section of the chimney at a time, low sections first, while someone watches inside for the leak to appear.
Working from the bottom up keeps the result clear, since water run at the top would soak everything below it. The test takes time, and we schedule it with you, but it replaces guesses with a location. The test also confirms the repair afterward, since the same water on the same spot should now stay outside.
Stone, joints, backing and base, in writing
- Build identified as full stone, anchored veneer or adhered veneer
- Loose stones counted, reset on fresh beds and repointed
- Cleaning method tested on the stone and named on the ticket
- Water repellent recommended only after repairs have cured
Stone chimney questions from San Marco
Can you match my stone?
We look for the closest current match and also consider moving stones from a hidden face to the repair. You see the options and approve a sample before any stone is removed.
Will the new mortar look different?
It starts darker and dries lighter, which is why we cure test samples and compare them before work begins. The joint style is matched as well as the color.
More services in San Marco
-
-
-
-
-
-
Learn more about stone chimney repairAll services in San Marco
Build first, then the joints
Say what has shifted or fallen when you call (904) 920-5495, and we book the free look in San Marco.
Free Inspection