Family-run gas log installation in Panama Park

Your Panama Park gas log set priced part by part, with the gas line named for the gas trade and no hidden fees.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Gas log pros who measure first in Panama Park

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Every log is set to the manual's photos, so the flame stays clean.

Free inspection and estimateYour Panama Park firebox, flue, damper and room are measured against the set's manual at no charge before anything is bought.
Upfront pricing, no hidden feesSet, burner, clamp, cleaning and any repairs are priced in writing, with the gas trade's part named.
100% satisfaction guaranteedIf the flame is sooty or the set will not stay lit after our installation to the manual, we come back.

Call (904) 920-5495 Free Inspection

Soot on the logs

Black soot creeping over gas logs means the flame is touching them where it should not, or burning short of air. Left alone, it spreads onto the firebox and the room. Soot on the glass doors or the face of the firebox is part of the same story.

The logs get reset to the manual's layout, the burner ports and ember bed are checked, and the damper and air supply get a look. Soot on the gas logs in your Panama Park fireplace? Book a free look at (904) 920-5495.

Panama Park lies within Duval County. Panama Park is inland.

What gas log installation covers in Panama Park

Burners leveled and centered in the firebox
Outside air and clean-out doors sealed for vent-free
Inherited sets identified and reset
Yearly service set up from install day

Call (904) 920-5495 Free Inspection

From wood fireplace to gas logs in Panama Park

Measure firebox and room
Firebox, chimney height and, for vent-free sets, the room are checked against the manual.
Clean and clamp
Soot and debris come out of the fireplace, and vented sets get their permanent damper clamp.
Connect and test
Once gas reaches the valve, the set is connected, leak tested and its pressure read.
Place logs and light
Logs and embers go where the manual shows, and we light the set with you.

Soot on inland gas logs

Sooty logs in Panama Park point to placement, the burner or air, not the weather.

Placement is corrected first, then the burner and air.

10% off any service booked within 72 hours of inspection

Gas log installs in Panama Park come 10% off, with the logs placed to the maker's diagram.

Call (904) 920-5495 Free Inspection

A lip at the front of the firebox

The front edge of the firebox floor matters to a log set. One maker's vented burner may not go into a fireplace with an ash lip or recess deeper than three quarters of an inch, and measures the required depth from inside the lip.

A raised lip can also affect how the burner pan sits and how the flame reaches the front logs. We measure the lip's height and the depth behind it on the first visit, so a set that cannot sit properly is ruled out before you buy it. A step at the front also affects how evenly the flame reaches the front logs.

A level floor under the burner

Burners are built to sit flat. One maker's manual says the fireplace floor must be level and smooth, since a burner pan that rocks or tilts changes how gas spreads through it and how the flames rise around the logs.

Old fireboxes can have sunken bricks or a rough ash-worn floor. We check the floor with a level before setting the burner, shim or correct it where the manual allows, and write up firebox floor repair separately where the floor itself needs work. The burner is then centered and secured as the manual shows. A shim is used only where the manual allows one.

The gas on the rating plate

Each log set is built for one fuel, and its rating plate names it. One vented burner's manual states that it is not field convertible for use with other gases, and says not to install it if the house's gas differs from the plate.

Some vent-free sets are built to run on either gas, shipped set for propane and converted to natural gas by the installer following the maker's instructions. We read the plate before installation and make sure the set matches the gas at the house, since a mismatch is not something to adjust around.

Firebox, room and damper on paper

Flue, damper and firebox cleaned and inspected before the burner goes in
Glass doors and frame checked for airflow and opening size
Outside air ducts and ash doors closed off under vent-free sets
Set, gas, clamp and readings recorded on the ticket

Gas log questions from Panama Park

Can gas logs go into any fireplace in Panama Park?

No. Vented logs need a sound fireplace and a chimney that draws, while vent-free logs need a big enough room where the rules allow them. Both are checked on a free visit.

Can I convert my log set to propane?

It depends on the set. Some are not convertible in the field at all, and others convert with the maker's instructions. The rating plate and manual decide.