Recessed electric fireplaces installed in Nocatee

A flush, level, working electric fireplace in your Nocatee room, installed under our 100% satisfaction guarantee.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Family-owned installation experts serving Nocatee

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Your Nocatee install is planned from the model's own manual, not from a generic template.

Free inspection and estimateThe wall and circuit at your Nocatee home are checked against the unit's manual at no charge.
100% satisfaction guaranteedA unit left crooked, loose or not working to its manual gets a return visit and a fix at no cost.
Family owned and operatedThe family crew that measures your wall is the one that mounts the unit, so nothing gets lost between visits.

Call (904) 920-5495 Free Inspection

A flush, built-in look

Set into the wall with its face flush or nearly so, a recessed electric fireplace, which reads like a built-in rather than an appliance hung on the surface. It needs a framed opening cut to the rough size in the manual, with blocking where the unit fastens. The trim that comes with the unit then covers the edge of the cut so the finish looks deliberate.

We check what is inside the wall first: studs, wiring, plumbing and ducts. Where the opening can go, we frame it, set the unit and fit its trim. Want a recessed electric fireplace in a wall at your house in Nocatee? Phone (904) 920-5495; the planning visit is free.

Nocatee lies near the coast. Nocatee falls within St. Johns County.

What an electric fireplace install covers in Nocatee

Wall-mounted units hung level on proper fixings
Heater outlet clearances marked on the wall
Cords routed out of sight, never on extensions
Heater run and cycle checked before we leave

Call (904) 920-5495 Free Inspection

How electric fireplace installation runs

Manual read in advance
Send the model number, and the installation section is read before we arrive.
Wall and circuit checked
Studs, wall contents, clearances and the circuit are checked against the manual.
Mounted, framed or inserted
The unit is hung, set into a framed recess or placed in a prepared firebox, with electrician work done in sequence.
Tested and handed over
Flame, heat, remote and cycling are tested with you, and the controls explained.

A dry, closed flue above the insert

Damp air drifting down an open flue is no friend to an electric insert. Closing the flue keeps the firebox dry.

We seal the flue above every insert we fit in Nocatee and record the method.

10% off any service booked within 72 hours of inspection

Electric fireplace going in at your Nocatee home? Book on the day of the wall check and 10% comes off.

Call (904) 920-5495 Free Inspection

What the rating label tells the installer

Every electric fireplace carries a rating label, usually on the back or side, giving the model, the serial number, the volts and the watts or amps. When the heat runs, that wattage is the load the circuit must carry.

The arithmetic is simple. A 1,500-watt heater on a 120-volt supply draws 12.5 amps. We read the label, look at what else shares the circuit and compare the total with the circuit's rating. That comparison decides whether an existing outlet will do or whether the manual's advice to use a dedicated circuit applies. A unit on a 240-volt supply draws half the amps for the same wattage, which is one reason larger built-ins use it.

Wall finishes around a recessed unit

Set inside a finished wall, a recessed unit has a manual that often limits which finish materials may be used around it and how close they may come. Some units allow drywall right up to the trim. Others ask for space around certain parts.

We check the manual for your model and finish the opening accordingly, fitting the trim supplied with the unit. Where you plan tile or stone around the fireplace, we note the manual's limits so whoever does that work has them in writing. Our scope covers the opening and the trim, not the wider wall finish. If the wall is to be painted after the install, we leave the trim masked and ready.

If you ever want wood fires again

Inserts do not have to be forever. If you ever want to burn wood again, the insert comes out, the flue closure is reversed and the fireplace and chimney are inspected before any fire is lit.

That is why we record how the flue was closed and where any cord or outlet was placed. A sealed damper can be reopened. A top sealing damper can be set to open again. The inspection before the first fire checks everything the insert covered while it was in. Nothing done for the insert should make a return to wood harder, and we plan it that way.

What we check on the wall in Nocatee

Heater outlet clearances marked for shelves and screens
Old gas line capped by a gas contractor, named in writing
Cord route that follows the manual and stays out of sight
Old unit removed and hauled away, where one is replaced

Before the unit goes in

Will I need a new circuit?

It depends on the unit's rating label, its manual and what else is on the circuit. If a dedicated circuit is needed, an electrician adds it, shown as its own item.

How long does an installation take?

A wall mount can take a few hours. A framed recess or an insert with flue work takes longer, and any electrician work sets the pace. The estimate gives the expected time.