Local gas fireplace repair for Nassauville homes

Standing pilot or electronic ignition, Nassauville units are tested free the way their makers' service charts describe.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Local gas fireplace experts for Nassauville homes

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

Gas piping belongs to a gas contractor or the utility, and we say so in writing when that is the fault.

Same-day serviceWhen the schedule has a gap, a gas fireplace in Nassauville that will not light can be looked at the same day.
Upfront pricing, no hidden feesYou see the reading that proved the fault, the part and its price in writing, and then you decide.
100% satisfaction guaranteedIf the fireplace still will not light or stay lit after our repair, we come back.

Call (904) 920-5495 Free Inspection

Test first, then order parts

Several parts in a gas fireplace can each stop it from lighting, and replacing them one at a time until it works is an expensive way to find the fault. We test before we replace. A thermocouple or thermopile gets a meter reading, a switch circuit gets checked at the valve terminals, a module gets taken through its lighting sequence, and the supply gets a pressure reading.

By the time an estimate in Nassauville lists a part, there is a reading behind it, and that reading is written down beside the part. You can ask to see any reading we took. The first look at your Nassauville gas fireplace costs nothing, and (904) 920-5495 is the number.

The coast is close to Nassauville. Mount Olive Missionary Baptist Church can be found in Nassauville.

Pilot, ignition, burner and vent

Thermocouple or thermopile output read with a meter
Flame rod and spark electrode checked on electronic units
Burner ports cleaned and ember material reset
Glass gasket checked on sealed units

Call (904) 920-5495 Free Inspection

Plate, readings, part, test burn

Rating plate and symptom
We read the maker, model and gas type, then watch the unit try to do what you called about.
Readings against the chart
Thermocouple, thermopile or flame rod output and the gas pressures are measured and compared with the manual.
Failed part replaced
The part that tested bad is replaced with the maker's listed part, and the burner and logs are set right.
Test burn and vent check
The unit runs through a full cycle, and the vent termination outside is checked before we go.

Gas fireplace vents just back from the beach

Nassauville lies near the coast. Salt still reaches the vent termination there, and its screen and fasteners corrode sooner than they would farther inland.

Service visits in Nassauville include a close look at the cap, and replacement parts come from the vent maker's list.

10% off any service booked within 72 hours of inspection

Each gas fireplace repair in Nassauville comes 10% off, with fittings leak-tested before we leave.

Call (904) 920-5495 Free Inspection

The thermopile and the switch circuit

A thermopile is a bundle of thermocouple junctions wired together, and its larger output does more than hold the valve open: it powers the valve's main operator through the wall switch or remote receiver. That makes the switch circuit part of the fuel system. A long wire run, thin wire, a corroded terminal or a worn switch can each drop enough voltage that the burner will not come on. The maker's chart gives the readings to take at the valve terminals, with the switch open and closed, and a short jumper across the switch shows whether the switch or the wire is at fault.

Receivers, handsets and pairing

Remote-controlled gas fireplaces have a receiver near the valve, which may run on its own batteries and carry a switch with on, remote and off positions. The receiver and handset are paired with a learn button, and on some models a battery change or a power loss can unpair them.

On millivolt units the receiver works like a wall switch in the thermopile circuit. We test the handset signal, the receiver output at the valve and the batteries under load, and replace only the part that fails. A receiver from another model is not substituted, since the pairing and the valve connection are specific to the system.

Termination hardware near salt spray

Salt spray corrodes steel faster than inland air does, and a gas fireplace's vent termination sits outside in whatever the wind carries. On a vent cap, rust shows first at fasteners, screen mesh and cut edges, and a screen that corrodes shut restricts both exhaust and intake on a direct-vent unit. Close to the coast, we look at the termination cap, its screen and its fasteners closely on each service and note early corrosion before it spreads. Replacement caps come from the vent maker's list for that system, including any corrosion-resistant option the maker offers. Stainless fasteners are used where the maker's list offers them.

Readings, parts and the vent check

Inlet and manifold pressure measured at the valve test ports
Leak check with solution on each connection opened or replaced
Glass gasket and seal checked on sealed direct-vent units
Spill switch tested on natural vent units, and not bypassed

Gas fireplace questions from Nassauville

Do you service propane gas fireplaces?

Yes. Propane units use the same controls with different orifices and pressures, and we confirm the gas at the rating plate first. The tank and supply piping are the propane supplier's.

Will I pay anything for the written estimate?

No. The estimate is free and in writing, priced upfront with no hidden fees. The 10% off for a repair booked within 72 hours is shown on it.