Local chimney crown repair in Murray Hill

Each new Murray Hill crown gets a proper bond break at the flue tile, so heat from the flue cannot crack it. Crown checks are free.

Family owned and operated
Free inspection and estimate
Same-day service available
Upfront pricing, no hidden fees

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

or call (904) 920-5495

Why Choose Us

Crown repair experts for Murray Hill chimneys

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off when you book today

The brick under the crown is checked too, because a new top on loose courses will not last.

Free inspection and estimateWe map the cracks on your Murray Hill crown and check the brick under it at no charge.
Upfront pricing, no hidden feesCoating and recasting are both priced on paper, so you see the difference before choosing.
100% satisfaction guaranteedIf the finished crown is not right, tell us and we come back to put it right.

Call (904) 920-5495 Free Inspection

Crown work before selling a house in Murray Hill

A cracked crown is an easy item for a buyer's inspector to spot from the roof, and it tends to show up on the report with a vague note about water intrusion. Dealing with it first takes that item off the table.

When a seller in Murray Hill calls, the scope stays at what the crown needs, whether a coating or a recast, and the paperwork at the end describes what was done with the materials named. A buyer reading that record knows the top of the chimney was dealt with properly instead of painted over. Relaid brick is matched to the rest as closely as the stock allows. We check the cap and flashing on the same free trip to your Murray Hill crown; call (904) 920-5495.

Murray Hill is one of the named neighborhoods of Jacksonville. Murray Hill falls within Duval County.

What's Included

Crown work from crack map to cure

Cracks mapped and measured before any repair is chosen
Wider cracks filled before a crown coating goes on
Drip groove cast under the overhang
Crown sloped so water runs off toward the edges

Call (904) 920-5495 Free Inspection

How It Works

How crown repair runs

Crown checked from the roof
We look at the slab, the brick right under it and the seal around each flue, then write down the option that fits with its price.
Old top cleaned or torn off
For a coating, the crown is cleaned and the wider cracks filled. For a recast, the old top comes off down to sound brick.
Coating brushed on or crown poured
A coating goes on in dry weather inside the maker's temperature range. A recast is formed with a slope, an overhang, a drip groove and a sealed joint at every flue.
Curing, then the cap goes back
New concrete stays covered and damp while it cures. The cap is refastened once the crown can hold it, and we show you the finished top.

Local Conditions

Plain steel in crowns away from the coast

Away from salt, the steel inside a cast crown is at less risk of rusting, but it still needs its full cover of concrete. Steel lying on the brick or near the surface rusts from ordinary rain and splits the slab.

When we recast a crown in Murray Hill, the reinforcement sits on supports within the thickness of the slab so the concrete surrounds it.

10% off your first service when you book today

Your first crown repair at an address in Murray Hill gets 10% off when booked today.

Call (904) 920-5495 Free Inspection

Weather windows for a crown coating

A crown coating is only as good as the day it goes on. The coating maker's data sheet sets the rules: a surface and air temperature range, a clean and dry surface, and no rain due before the coating has had time to set, unless the crown can be protected.

That means crown coatings are scheduled for dry spells, and a day that looked fine can be called off if showers move in. We also cool a sun-heated crown with a light mist where the data sheet allows it, since a hot surface can make the coating skin over too fast.

Giving a crown enough slope

Slope is what makes a crown shed water, which is why the residential code's crown section asks for it, and a flat top defeats that purpose. Water that sits on it soaks into the concrete, finds every hairline crack, and carries dirt and dissolved salts into the pores.

The slope runs from the flue tiles down to the outer edge on every side, steep enough that water moves off promptly without pooling at the tile. Where two or more flues share the crown, the surface between them slopes away as well, so no low spot is left to hold water. The slope is checked with a level before the concrete sets.

How far the flue tile stands above the crown

Once the crown is finished, the flue tile should stand clear above it. The BIA's chimney note has the liner stand 2 inches or more proud of the cap, which keeps water running across the crown from spilling over the rim into the flue.

A tile cut flush with the crown, or buried in it, fails that test. When a tile is too short, the options are a new top tile or a crown shaped lower around it, and the tile's condition decides which applies. Tile height is measured from the finished crown surface instead of the old top that came off.

Free Inspection

Measured on the crown in Murray Hill before pricing

Top courses of brick relaid before the new crown goes on
Reinforcement and concrete mix for a cast crown
Chimney cap removal and reinstallation, with how it is fastened
Cure time before the cap goes back and the fireplace is used

FAQ

Before your crown is coated or recast

Is Murray Hill inside your crown repair area?

It is. On your Murray Hill chimney we first identify the type of top and map its cracks, then put a coating or a recast in writing. Call (904) 920-5495 to book.

Can a crown be repaired in the rain?

No. Coatings and fresh concrete both need dry conditions for a set time after they go on. Crown work is scheduled for dry weather, and rain protection is on hand in case a shower arrives early.

Our Services