Local gas fireplace installation in Lake Geneva
Heater or decorative, the Lake Geneva unit is chosen from its listing and the room it has to suit, at a free inspection by local pros.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Gas fireplace installation specialists who vent to the manual
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Every clearance comes from the unit's manual, from the header height to the mantel depth.
- Family owned and operatedOne family business frames, vents and starts up the unit in Lake Geneva, and lines up the gas and electrical trades.
- Workmanship warrantyThe workmanship warranty applies to our venting, framing and start-up, and the unit keeps its maker's terms.
See-through and corner units
Not every gas fireplace has one face. See-through units open into two rooms, corner units show two sides of the flame, and some models show three. Each design has its own framing drawing, clearances on more than one side and its own vent options, and a see-through unit's framing has to work from both rooms.
We review the drawing with you in both Lake Geneva rooms, confirm the vent can leave from where the unit sits, and note any finish that has to be matched on both faces. Both faces also need the barrier screen and service access the manual calls for. Natural gas or propane at your Lake Geneva home? Say which on the call to (904) 920-5495.
Lake Geneva lies within Clay County. Lake Geneva does not reach the coast.
Gas fireplace installs around Lake Geneva
- Termination kept clear of windows, soffits and the meter
- Gas line to the shutoff valve assigned to a gas contractor
- Start-up readings and leak check at the valve
- Walk-through of your new Lake Geneva unit and its manual
From vent exit to first burn in Lake Geneva
-
Vent exit found first
We find where the vent can leave the house within the manual's clearances, then pick the unit to suit.
-
Frame and run the vent
The enclosure and header are framed to the drawing, and the vent is run with its supports, pitch and firestops.
-
Trades, wiring and gas
Wiring goes in before the wall closes, and the gas contractor brings the line to the shutoff valve.
-
Start-up and inspection
Pressures are read, joints leak checked, the inspector signs off, and we go over the controls with you.
Propane installs in Lake Geneva
A propane fireplace runs from a tank outside the house, and the manuals are clear that the tank never goes inside a structure.
For propane installs in Lake Geneva, the supplier sets the tank and runs the line, and we coordinate the start-up with them.
10% off any service booked within 72 hours of inspection
Settling on a model for a room in Lake Geneva takes time, and the 72 hours give you some.
Soffits, eaves and porch ceilings
Heat and exhaust rise, so the manual sets how far below a soffit or eave a termination has to sit. A ventilated soffit, with openings that could take exhaust into the attic, needs more distance than a solid one. Porches and decks are handled separately: a termination may sit under a veranda, porch or deck only when it is open on the sides the manual specifies, and at the height it gives. Vinyl soffits can deform from heat, and some makers warn against terminating beneath them.
We check each overhead surface near the chosen spot. The measurements go on the plan.
Wiring before the wall is closed
Remote receiver, wall switch and blower wiring are run before the finish goes on, as the manuals ask, because running it afterward means cutting into the new wall. A millivolt wall switch needs its own low-voltage wire to the valve, sized and limited in length as the manual shows.
A blower or an electronic-ignition unit needs an outlet in the location the manual gives, added by an electrician. We rough in the low-voltage wiring during framing and confirm the outlet is in place before the drywall goes up. The wire runs are labeled at both ends for whoever services the unit later.
The volume rule for B-vent units
A B-vent fireplace takes its combustion air from the room, so the fuel gas code limits where it can go. In a bedroom, it is allowed only when the room has at least 50 cubic feet of volume for each 1,000 Btu per hour the unit burns, the code's standard method.
A small bedroom can fail that test with a modest unit. A direct-vent unit, which takes all its air from outside, is not held to the same volume rule when installed to its listing. We do the arithmetic from the room's measurements before recommending either. Ceiling height counts, so a tall room holds more volume than its floor area suggests.
Unit, vent route and trades on paper
- Framed opening and header height taken from the manual
- Termination spot measured to windows, soffits, corners and walks
- Service access panels left removable after the finish
- Outlet for a blower or ignition, added by an electrician where needed
Gas fireplace install questions from Lake Geneva
Is a direct-vent unit or a B-vent unit better?
It depends on the room and the route. A direct-vent unit is sealed and can exit through a wall, and it is allowed in bedrooms when installed to its listing. A B-vent unit uses room air and needs a vertical vent through the roof.
Does the 10% discount cover a gas fireplace installation?
It does, when you book the installation within 72 hours of the free inspection. The written estimate shows the 10% off as its own line.
More services in Lake Geneva
-
-
-
-
-
-
Learn more about gas fireplace installationAll services in Lake Geneva
Free gas fireplace planning visit
A direct-vent unit needs a path out through a wall or the roof, and our gas fireplace experts find it on your home in Lake Geneva. Call (904) 920-5495.
Free Inspection