Family-run fireplace insert installation in Julington Creek Plantation

From measuring to the first fire, Julington Creek Plantation insert installation with the steps and the cure times written down.

Fully licensed and insured
Locally owned
Family owned and operated
Same-day service

Call (904) 920-5495 Free Inspection

Get Your Free Inspection

Get a quote for chimney and fireplace repair and installation in Jacksonville.

Quicker by phone? Call (904) 920-5495

Call our chimney crew

(904) 920-5495 Free Inspection

Insert specialists who measure first in Julington Creek Plantation

Locally owned in Jacksonville
Family owned and operated
100% satisfaction guaranteed
Free inspection and estimate
Same-day service available
10% off any service

The old damper is fixed open or taken out, so the liner cannot be pinched later.

Free inspection and estimateYour Julington Creek Plantation firebox, chimney height and hearth are measured against the insert's manual at no charge, before anything is ordered.
Upfront pricing, no hidden feesEvery part of the job is priced before ordering, from repairs to the rain cap, and nothing is added without your yes.
100% satisfaction guaranteedIf the insert smokes or draws poorly after installation to its manual, we come back and set it right.

Call (904) 920-5495 Free Inspection

Firewood kept close to the insert

Stacking wood right beside the insert is convenient, but insert manuals keep stored wood out of the installation clearances and out of the space needed to load and clear ash. Those clearances protect the floor and walls as well as the mantel, and they apply to baskets and furniture too.

On install day we show you the clearance lines for your model so you know where wood, furniture and baskets can sit safely. Setting up the room around a new insert in Julington Creek Plantation? Our insert specialists will help you lay it out; call (904) 920-5495.

Julington Creek Plantation lies within St. Johns County. Julington Creek Plantation does not reach the coast.

Liner, surround, clearances and hearth

Dampers locked open or removed for the liner
Fireplace repairs finished before the insert goes in
Surrounds sealed or left open per the manual
Inserts in factory-built fireplaces only where both allow it

Call (904) 920-5495 Free Inspection

Measure, repair, reline, fire

Measure against the manual
Firebox, chimney height, hearth and clearances are checked against the insert's table before ordering.
Repair and clean first
Fireplace repairs are made and cured, and the flue is cleaned before the liner goes up.
Liner, plate and cap
A listed stainless liner runs to the top, closed with a top plate and a rain cap.
Set, seal and fire
The insert and surround go in as the manual directs, and the first fire is run with you.

A second flue on the chimney in Julington Creek Plantation

Some chimneys in Julington Creek Plantation carry more than one flue. An insert needs one of its own, not shared with another appliance.

We trace each flue before choosing the liner path.

10% off any service booked within 72 hours of inspection

Insert measured through us in Julington Creek Plantation? Book it inside three days and 10% comes off.

Call (904) 920-5495 Free Inspection

Minimum chimney height for draft

Chimneys pull smoke up and air in because warm gas in the flue is lighter than the air outside, and a taller column pulls harder. One insert maker sets a minimum chimney height of 15 feet for its model.

We measure from the hearth floor to the top of the flue, the same measurement the maker uses to size the liner, and compare it with your model's figure. Where the chimney is short, the options are a model with a lower requirement or a different plan for the fireplace, and we set those out before any order is placed, with the measurement written down.

The short positive connection

The alternative to a full liner is a positive flue connection: a throat blocker plate sealed into the damper area and a short connector pipe from the insert collar up into the first section of the existing flue lining. One maker accepts it in the United States, while recommending the full liner.

The same maker notes that local codes may require a clean-out door with a short connection. We explain what the short connection saves and what it costs you in cleaning and draft, and the estimate shows both options when the fireplace allows both. The choice is yours once the differences are on paper.

The tag that records a modified fireplace

When a fireplace has been altered to take an insert, one maker supplies a metal tag to be fastened to the fireplace's back wall. The tag warns anyone who removes the insert later that the fireplace was modified, for example by cutting the damper, and should not go back to open fires without a check.

We fix the tag in place where the manual calls for it and note on the ticket what was changed. That record matters if the house is sold or the insert is taken out years from now, when nobody remembers what was done to the damper or the smoke shelf.

Fireplace, flue and hearth on paper first

The four firebox dimensions set beside the insert maker's size table
Full-length stainless liner, listed to UL 1777, matched to the collar
Top plate trimmed, seated and sealed, with a rain cap on the liner
Hearth depth and ember protection checked against the manual

Wood insert questions from Julington Creek Plantation

How long does an insert installation take?

The install itself is usually one visit once the insert, liner and parts are in. Repairs to the fireplace come first and need their drying time, which the estimate shows.

Is the inspection before an insert free?

Yes. Measuring the firebox, checking the chimney and writing the estimate cost nothing, and the price is set out upfront. Order the insert within 72 hours of that visit and the job is 10% off.