Tuckpointing chimneys in Jacksonville Beach by local masons
A free survey of every face in Jacksonville Beach, same day if the calendar allows, and 10% off repointing you book within 72 hours.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Family-owned mortar specialists serving Jacksonville Beach
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Head joints are cut by hand, so the brick edges stay sharp.
- Free inspection and estimateEvery face of your Jacksonville Beach chimney is scratch-tested and sketched at no charge.
- 100% satisfaction guaranteedIf the new joints are not sound, full and matched as agreed, we come back and fix them.
- Family owned and operatedA family masonry crew does the survey and the work, so the person who priced a face is the one who repoints it.
Shadow lines along the joints
From the yard, a chimney with worn joints looks striped. Each mortar line sits back from the brick face, catching a shadow, while a sound chimney reads almost flat. The deeper the shadow, the more mortar has gone.
Recessed joints hold water against the brick and let it into the wall. Repointing restores the joint to the face so rain runs off. We measure how far back the mortar has gone on each side before pricing. Chimney looking striped from the street in Jacksonville Beach? Call (904) 920-5495 and ask our masonry pros for a free look.
Jacksonville Beach sits in Duval County. The 2020 Census counted 23,830 residents in Jacksonville Beach.
Raked, filled, tooled and cured
- Worn joints raked to sound depth
- Joints cleaned and dampened before filling
- Joints tooled to match and shed water
- Joints on your Jacksonville Beach chimney priced face by face
From the scratch test to cured joints in Jacksonville Beach
-
Every face surveyed
Joints are scratch-tested at several heights and the failed courses marked on a sketch.
-
Joints raked and cleaned
Old mortar comes out to sound depth, head joints by hand, then joints are cleaned and dampened.
-
Filled in layers and tooled
Matched mortar goes in stage by stage, then is tooled to the original profile.
-
Cured and cleaned up
Fresh joints are protected while they cure, the faces brushed and the roof cleared.
Salt on the brick and joints in Jacksonville Beach
Salt carried on the ocean wind settles on chimneys along the coast, and water moving through the masonry carries salts to the surface as it dries.
When we find white deposits on a chimney in Jacksonville Beach, we brush them back to see the joints beneath before deciding what to repoint.
10% off any service booked within 72 hours of inspection
One face or all four, repointing in Jacksonville Beach comes 10% off.
Keeping the original joint width
New joints should be the width of the old ones. A joint widened by a careless grinder or a chipped brick edge shows as a thick line of mortar, and the wider joint carries more of the wall's movement than it was designed to.
Preservation Brief 2 treats keeping the original width as part of a good repointing job. We cut inside the old mortar, stop at the brick edge and repair any chipped edge before filling. Where earlier work has already widened joints, we note it and fill them neatly rather than making them wider still.
Why the top courses wear first
Above the roof line, a chimney stands exposed on all four sides. Rain hits it from all directions, sun heats it through the day, and water that gets past the top soaks the upper courses first.
It is common to find sound joints low on the stack and failed joints near the top. We survey both so the quote fits the damage. Where only the top courses need work, the rest is left alone, and the report says the lower joints were tested and found sound. Those upper courses also carry the chimney top, so their condition affects everything above the roof line.
Full joints against wind-driven rain
On chimneys close to the ocean, storm wind drives rain hard against the masonry, and any gap along a joint edge becomes a way in. Brick Industry Association guidance on water penetration stresses full mortar joints and tooled profiles for exactly that kind of exposure.
So near the coast we pay particular attention to filling joints completely, with no voids behind the face, and to tooling them tight against the brick. We also check the faces that take the most direct weather, since wind-driven rain wears their joints soonest. Joints on those faces are raked and refilled with extra care at the brick edges, where rain finds its way in first.
Joint findings written down before pricing
- Head joints cut by hand, and where a grinder is used
- Color matched from a cured test batch shown to you first
- Caulk or skim patches to remove before repointing
- Loose top courses that need relaying rather than repointing
Repointing questions from Jacksonville Beach
Can you repoint just part of the chimney?
Yes, when the rest is sound. We scratch-test every face, and the quote covers only the courses and faces that need it, with the others noted as tested and sound.
What if you find loose bricks while raking?
We stop and show you. A loose brick or course needs relaying or replacement, which is priced as its own item before we continue.
More services in Jacksonville Beach
-
-
-
-
-
-
Learn more about chimney tuckpointingAll services in Jacksonville Beach
Book a joint survey before the next storm
Our masons test the joints on all sides of your Jacksonville Beach chimney and put a written price on each. Call (904) 920-5495.
Free Inspection