Gas fireplace log replacement in Fruit Cove
Natural gas or propane, the gas logs in Fruit Cove are set to the rating plate and lit with you on install day.
- Fully licensed and insured
- Locally owned
- Family owned and operated
- Same-day service
Get Your Free Inspection
Get a quote for chimney and fireplace repair and installation in Jacksonville.
Request received
Thank you. We will call you shortly to set a time.
Quicker by phone? Call (904) 920-5495
Local gas log specialists who set logs to the manual
- Locally owned in Jacksonville
- Family owned and operated
- 100% satisfaction guaranteed
- Free inspection and estimate
- Same-day service available
- 10% off any service
Gas logs in Fruit Cove go in only after the firebox has been measured against the set's table.
- Free inspection and estimateYour Fruit Cove firebox, flue, damper and room are measured against the set's manual at no charge before anything is bought.
- Upfront pricing, no hidden feesSet, burner, clamp, cleaning and any repairs are priced in writing, with the gas trade's part named.
- 100% satisfaction guaranteedIf the flame is sooty or the set will not stay lit after our installation to the manual, we come back.
Who brings the gas to the fireplace
Gas logs need gas at a valve in the firebox, and the pipe that brings it there is a separate trade covered by NFPA 54. Whoever handles gas at the house, a gas fitter, the utility or the propane company, runs and sizes that line. The line is sized for the set's full flow, not only for the pilot.
Their part is named on the estimate, and our connection, leak test and pressure reading follow once gas reaches the valve. Setting up gas for new logs in Fruit Cove? Start the plan at (904) 920-5495.
The coastline lies beyond Fruit Cove. Fruit Cove falls within St. Johns County.
Gas log work for Fruit Cove fireplaces
- Flues and dampers cleaned before the burner goes in
- Burners leveled and centered in the firebox
- Logs, embers and media placed to the manual
- Lighting the new set together in your Fruit Cove living room
How gas log installation runs
-
Measure firebox and room
Firebox, chimney height and, for vent-free sets, the room are checked against the manual.
-
Clean and clamp
Soot and debris come out of the fireplace, and vented sets get their permanent damper clamp.
-
Connect and test
Once gas reaches the valve, the set is connected, leak tested and its pressure read.
-
Place logs and light
Logs and embers go where the manual shows, and we light the set with you.
Glass doors on inland fireplaces
Many fireplaces in Fruit Cove have glass doors. With gas logs, the doors stay fully open while the set burns.
We check the frame for airflow when we measure.
10% off any service booked within 72 hours of inspection
The logs, the burner and the setup are all discounted.
Fresh air in a tightly built house
Air leaking around doors and windows can supply a vent-free set in an older house, but not in a tight one. One maker says a home with a continuous vapor retarder, weather stripping on doors and windows, and sealed joints around frames and sole plates must have additional fresh air from outdoors.
Its manual describes ways to bring that air in from outside or from adjoining rooms. We ask about the house's construction and recent upgrades before recommending a vent-free set, since a tight house changes the answer. A worksheet in the manual turns that into numbers.
Protecting the valve during pressure tests
Gas piping gets pressure tested, and those tests can damage a log set's valve. One maker requires the appliance and its main valve to be disconnected from the supply piping during tests above half a pound per square inch, and isolated by closing its shutoff valve during tests at or below that.
When the gas trade tests a new line to the fireplace, we coordinate so the set is disconnected or isolated as the manual requires. It is a small step that saves a valve. A valve damaged by test pressure can leak or fail to regulate.
Broken and chipped logs
Cracked or broken logs change the flame around them. One vent-free maker says not to run its set with a broken log or with a chip the size of a dime or larger, and another maker's vented manual says not to operate with any log broken.
Replacement logs come from the set's own parts list, placed where the originals sat. We do not mix logs from other sets, even when they look alike, because their shape and position are part of how the burner was tested. Ordering by the set's model number keeps the shapes right.
Measured in Fruit Cove before a log set is ordered
- Firebox front width, rear width, depth and height against the set's table
- Chimney height from the hearth to the top for a vented set
- Flue, damper and firebox cleaned and inspected before the burner goes in
- Glass doors and frame checked for airflow and opening size
Before a log set goes in
Why are my gas logs getting sooty?
Flame touching a log it should not reach, a burner or ember bed out of order, or a shortage of air. Logs go back to the manual's layout and the burner and air get checked.
Can I convert my log set to propane?
It depends on the set. Some are not convertible in the field at all, and others convert with the maker's instructions. The rating plate and manual decide.
More services in Fruit Cove
-
-
-
-
-
-
Learn more about gas log installationAll services in Fruit Cove
Book a gas log check in Fruit Cove
Know the log set you like? Tell us on (904) 920-5495 and our experts measure your Fruit Cove firebox against it.
Free Inspection